Results 1 to 4 of 4
  1. #1
    Join Date
    Dec 2012
    Location
    Saskatoon
    Posts
    1

    Test ports in doors

    Hey guys and gals, new here and I think I have this in the right forum?

    We had a spec come through for a job that is asking for "test ports in doors" and now I need to figure out something to spec or design to make that happen and I thought I would come here to see what everyone likes/hates or where I would get something? We had one suggestion to make a port out of PVC fittings but my problem is we are putting it in a unit with 1" OD doors so I am having trouble finding parts that will fit inside.

    Ideally I would like a single part, just wondering if anyone out there knew of anything good that works and will seal the hole when not being used for testing.

    Thanks.

  2. #2
    Join Date
    Nov 2011
    Location
    Charleston, Wv.
    Posts
    1,504
    sounds like you're asking about holes to insert pitot tubes in duct for airflow checks? it's just a 1/4"-3/8" hole. most people plug them with snap in caps.

  3. #3
    Join Date
    Dec 2002
    Location
    in a house, Appomattox, Va.
    Posts
    3,318
    local N B Handy had a part sheet on wall for grey metal south, I think.

    showed a # of duct fitting they made, damper parts, etc.

    a flange w/cap was shown there for a test port as well.

    maybe can look up on their site?
    Col 3:23


    questions asked, answers received, ignorance abated

  4. #4
    Join Date
    Dec 2002
    Location
    in a house, Appomattox, Va.
    Posts
    3,318
    Col 3:23


    questions asked, answers received, ignorance abated

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event