Sounds like there isn't a program controlling that output. Or the program isn't being called for by the Master Program
I am running Delta 3.40 on a vav system with radiant hot water heating along the perimeter. When I open up the VAV graphic and click on the rad graphic and open it up, in the tab I am getting "no signal" and "no source" in the tab. I can control the actuator by going from auto to manual but can not get the valve to open and close based on the space temp. Any thoughts would be highly appreciated.
Sounds like there isn't a program controlling that output. Or the program isn't being called for by the Master Program
Follow me @blankscole
Thanks for the reply. What is my next step??
First of all do you have programming access through Orcaview or Orcaweb? If not... Call someone who does.
Sent from my BlackBerry 9900 using Tapatalk
Follow me @blankscole
Yes, I have full programming access via Orcaview.
Ok. Well you next step is to now setup a program to control the output. What is it that you are controlling?
Sent from my BlackBerry 9900 using Tapatalk
Follow me @blankscole
Thanks. I am controlling a zone valve serving perimeter radiant hot water heating.
Have you tired to contact the contractor who installed your Delta system for support?
In case of malfunction-Reconnect brain BEFORE starting mouth.
Is ESC your local Delta rep?
Sent from my BlackBerry 9900 using Tapatalk
Follow me @blankscole
No, Kimco Controls in Kelowna is my local Delta vendor. I could contact DDC support but I would like to try and sort this out myself. Thanks
I might be able to help you. Email me.
Any help is appreciated...I can't get your email from your profile so can you email me? Email is in my profile.
Can you email me? I am unable to send you a PM.
Sent from my BlackBerry 9900 using Tapatalk
Follow me @blankscole
I don't see an email in your profile.
I have updated my profile to include my email.....thanks!
Did you get this problem resolved?
Sent from my BlackBerry 9900 using Tapatalk
Follow me @blankscole