Results 1 to 5 of 5

Hybrid View

  1. #1

    Where to buy a wall mounted air handler simulator

    Hey folks,

    I would like to buy an air handler simulator for my company's training room to do practice controls programming and troubleshooting. I know there are a plethora of great graphical simulators out there, but I have some old-fashioned customers and techs that I believe would do far better by hands on with an old-fashioned wall-mounted simulator. Any suggestions on who to contact or where I can shop for one? Any and all assistance would be greatly appreciated.

  2. #2
    Join Date
    Mar 2007
    Posts
    366
    You could make one. With ecm motors becoming widely available and "competitively priced" it wouldn't be much of an investment. ECM motors make an easy and effective simulator for a VAV AHU.

  3. #3
    Join Date
    Dec 2006
    Location
    What? Who? Where?
    Posts
    1,692
    "Open is as open does." - Forrest Gump
    "Can't we all just get a Lon?" - Garry Jack
    "BACnet: integration or interrogation?" - The Janitor
    "Open protocols? You can't handle open protocols!" - Nathan R. Jessup
    “What’s that? Aaa… open protocols? Don’t talk about…. open protocols? Are you kidding me? Open protocols? I just hope we can hardwire an interface!” - Jim Mora http://www.youtube.com/watch?v=U7fjDS0jKiE

  4. #4
    Join Date
    Jan 2003
    Location
    USA
    Posts
    1,670
    They are not that hard to build in-house for little $$.

    Most I have done consist of an airflow diagram with LEDs indicating the binary points. For analog points 10 segment bar graph LEDs work great. https://www.sparkfun.com/products/9935 You can get fancy and use small 24v fans and small actuators.

    Many moons ago I built a demo with a resistor tied to a temp sensor. It was great for teaching PID loop tuning, PWM, ON/OFF control principles. The resistor is wired in a dead short and when energized it heats the sensor. Output and feedback in controller for next to no $$$.

    Glossing over the details, but with a little imagination and less than $50 you can have a pretty nice simulator for teaching classes.
    Propagating the formula. http://www.noagendashow.com/

  5. #5
    Join Date
    Sep 2006
    Location
    Alaska
    Posts
    459
    I've seen them built out of plexiglass at the Johnson Controls Institute in Milwaukee.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event