Hey people, Looking for some feedback on a condensate problem. I have a small market that is below a restuarant. All drain lines from the restaurant are exposed in the ceiling of the market. So, were having an issue that when the ice machine purges, all of that cold water sits in the p-trap and the cast starts sweating. Same thing happens with the floor sink. I've done the obvious and insulated the lines with armaflex, glued and siliconed all the seems. Then wrapped with 10 mil tape. Seems all I've achieved is a water tight water vessel? Thought about using heat tape? Also thought about trying one of those heat exchangers for the incoming and purge water to get the temp down. Any ideas?