3 amp fuse in a 5 amp slot?
If I was you I would have done the smart thing... Called a service technician
were not allowed to give DIY advise to non pro members. If you are a tech, get your post count up and apply for pro membership. You will get all the help you need then, but until then you will not get any useable advice. What is a "Ducane Tech" a gas furnace is a gas furnace to a tech, they all work pretty much the same.
how many places do you have to post the same question?
The Food Stamp Program, administered by the U.S. Department of Agriculture, is proud to be distributing the greatest amount of free meals and stamps EVER.
Meanwhile, the National Park Service, administered by the U.S. Department of the Interior, asks us to "Please Do Not Feed the Animals". Their stated reason for this policy "... the animals become dependent on handouts and will not learn to take care of themselves."
from an excerpt by Paul Jacob in Sun City, AZ
Might of ended up saving $ by calling a professional ..
Sent from my SGH-T999 using Tapatalk 2
This thread is an eye opener for me. Working in a factory run testing units, they wont let me just change parts out if fuses are blowing. They ***** at me if I blow a second fuse without finding the problem, let alone just changing boards, blowers and thermostats. Is this how stuff is actually done in the field?
Merge your 3 threads on this into one.
Please don't make duplicate threads, thank you.
I've visit this , in other posts, before.
Start troubleshooting this systematically. Fuse all loads, including Common. Which fuse continues to blow? Then Trace the circuit flow through the bad fuse.
Remember, stat wire runs, without a blue(common) conductor, will not blow fuse but will energize a circuit if it is shorted. Unless it is going to a ground and transformer is also anchored to ground.
6 hours to blow may be overnheated fuse connection. Look for weak, heated fuse connection. This is obvious,Did you use an amp meter?
and none of us can figure it out either. We can only lead you in the right direction. Check your low voltage conductors and loads individualy. Please remember, You are not entitled to my knowledge nor that of anyone elses on this board. How about being a littless rude.
Originally Posted by Bmurph1409
Officially, Down for the count
YOU HAVE TO GET OFF YOUR ASS TO GET ON YOUR FEET
I know enough to know, I don't know enough
Liberalism-Ideas so good they mandate them
You have a time line here what sequence of events takes place every 6 hours? Remember the five basics of trouble shooting
Originally Posted by Bmurph1409
1 Talk to the operator
2 Accomplish a visual inspection
(Safety , Safety , safety )
3Attempt to operate the equipment
Important note : If there is a remote chance of possible damage to personnel or equipment SKIP THIS STEP.
4 Voltage checks
check supply voltage first , then control voltage
5 Use the documentation (i.e. ladder drawing) and the appopriate test equipment to logically troubleshoot the circuit and isolate the problem.
If you have replaced all the parts its possible something was rewired incorrectly.
Above all remember be safe if you do not have a good feel for you level of competency. Do get the correct help and learn from the pro.
Wait...pull the fuse before it pops, change furnace. Problem solved!
Don't worry zombies are looking for brains, you're safe...
Because there the EPA they have to monitor the beans sold there, because they only allow so many farts in one day.
Originally Posted by jtrammel
Experience is a hard teacher because she gives the test first, the lesson afterwards". - Vernon Law
"Never let success go to your head, and never let failure go to your heart". - Unknown
Disconnect the wires running to the condensing unit for low voltage and that will tell you it there is a problem at the condensing unit
Sent from my iPhone using Tapatalk