York YCUJ Millenium Recip, Program FLA
I got thrown on a mess for a new customer, His microboard was wrecked by salt water. He sent it out for repair and it was lost.
He purchased and installed a new one with no EPROM. That is where I came in, bought him a new EPROM, set up dip switches and checked safety set points.
Here is the question, How is FLA programmed into Microboard? I tried program+various York codes, 5144, 6144, ect. No luck.
Unit is ready to go, even started it briefly but quickly shut it down do to buzzing starter (rusty armature) which customer is repairing.
Two compressor 136 FLA each