Results 14 to 17 of 17
Thread: Crane doesn't reach.
-
11-27-2012, 08:48 PM #14
Professional Member
- Join Date
- May 2002
- Location
- evansville indiana
- Posts
- 892
Helicopter is the way to go ....however you would need to have all the units ready to be pulled and reset if not all at once at least in groups...
Unless you want to spend $5000 a lift ....
I participated in one at a shopping mall ...we set around 20 units in under four hours(scattered all over the roof ) ... but we had all the old ones ready to be pulled , four men on on the roof and four on the ground plus a couple floaters.
I remember one guy kept walking under the load right after the chopper lifted the units off the ground ....we kept telling him NO!,,,after awhile I just would turn my back .
They can lose their lift and "bounce" or drop a load .mikeacman
-
12-01-2012, 09:43 AM #15
just make sure the roof and parking lot are as clean as posible, the rotor blast will raise all the dust and loose debris.
-
12-02-2012, 01:50 PM #16
http://www.smarthvacproducts.com/pro...transport-tool
Try this out I have not personally used it but received a email thursday about it
Sent from my BlackBerry using Tapatalk please excuse typographical errorsIf you can not do it right, Why even do it at all?
-
12-05-2012, 09:57 PM #17
So u find anything else
Sent from my BlackBerry using Tapatalk please excuse typographical errorsIf you can not do it right, Why even do it at all?


Reply With Quote