Hi folks!

Im not sure where to start but I guess I can start with my tstat. If I manually select to fan (which should turn the fan on), It will not turn on.

Neither my AC or Heater will work and I suspect the fan motor is bad or my tstat.

The coleman has blinking lights to aid in troubleshooting and when I turn on my heater everything seems fine except the fact that my fan will not turn on so at that point the flame turns off and I get the blinking code - two blinks: which according to the troubleshooting guide means "primary circuit open"

I cannot find the primary sensor...only the two tempature sensors near the burners. I should have a total of three according the the schematic.

Coleman Evcon Model BGM06012C