Two ICP RTU gaspacks
1st one PGME60H150C/G030612118..thermostat blank, all that's running is the combustion fan motor, no call for heat, got 24v into the control board, but nothing on any of the lv terminals on the board.
2nd one, PGMD30G0601/L941968053... call for heat, combustion fan motor running, no spark, 24v to the module, no open limits.
On both units, i've determined that on #1 I have a bad board, on #2 its a bad ignition module. Am I correct or am i missing something.
As I mentioned in the past, my electrical troubleshooting is a little weak but if im getting 24v in shouldn't I get 24v out, if these controls are operating correctly? Thanks in advance.
A lack of planning on your part does not constitute a state of emergency on my part.