"Hey while your up there today give us a quote on the nitric scrubber bearing we think it's going out. We had it balanced two weeks ago to try to make it last."
Name:  ImageUploadedByTapatalk1351474852.720955.jpg
Views: 445
Size:  54.6 KBName:  ImageUploadedByTapatalk1351474877.049904.jpg
Views: 453
Size:  30.2 KB
Yes that is daylight you can see between the shaft and inner race. They put this bearing on a year or two ago. Then they tried to balance out a failing bearing on a critical machine instead of planning to change it.
Name:  ImageUploadedByTapatalk1351475041.854271.jpg
Views: 453
Size:  40.3 KB
Note the nice job they did previously cleaning the shaft with an angle grinder.
Name:  ImageUploadedByTapatalk1351475099.983081.jpg
Views: 429
Size:  41.5 KB
Here is their finished "get you by" we gave them.
Name:  ImageUploadedByTapatalk1351475176.530367.jpg
Views: 466
Size:  51.8 KB

Also on another blower we had to change out a busted sealtite fitting. I was real proud to see their great job they did wiring a 50hp motor. They used channel locks to get their wire nuts real tight! Motors love extra good connections like these.
Name:  ImageUploadedByTapatalk1351475613.905800.jpg
Views: 466
Size:  31.4 KB

Keep it up factory's I'm digging the double time!