Page 2 of 2 FirstFirst 12
Results 14 to 18 of 18
  1. #14
    Join Date
    Oct 2012
    Posts
    9
    Quote Originally Posted by jpsmith1cm View Post
    I think I see the problem, here.....



    Iffen he didn't know what he was doing, wanna bet it isn't set up right?
    He said he has installed like 15 of these units and never had a problem like this. Whats funny is there is no isssue with the heating system part of it.

  2. #15
    Join Date
    Oct 2012
    Posts
    9
    Quote Originally Posted by qwerty hvac View Post
    What kind of mixing vale is it?


    Sent from my iPad using Tapatalk HD
    Its a watts, it says "not antiscalding" on it

  3. #16
    Join Date
    Dec 2008
    Location
    Buffalo NY
    Posts
    3,107
    Is 140 the temp going into the valve?


    Sent from my iPad using Tapatalk HD
    Join http://scopeny.org/ Shooter’s Committee on Political Education

    The world is full of sheep,try not to join the flock.

    Support the Skilled Trades, Don't DIY

  4. #17
    Join Date
    Oct 2012
    Posts
    9
    Quote Originally Posted by qwerty hvac View Post
    Is 140 the temp going into the valve?


    Sent from my iPad using Tapatalk HD
    According to the controller for the unit, it is set at 140deg. So yes there "should be" 140deg water going into the mixing valve. However i can hang onto that copper pipe, while 140deg water is "supposably" flowing through it.

  5. #18
    Join Date
    Dec 2008
    Location
    Buffalo NY
    Posts
    3,107
    Quote Originally Posted by strokd66 View Post
    According to the controller for the unit, it is set at 140deg. So yes there "should be" 140deg water going into the mixing valve. However i can hang onto that copper pipe, while 140deg water is "supposably" flowing through it.
    So you don't have anything to measure that temp? That temp will tell the mixing valve what to do. Also when the valve is adjusted it has to be done slowly. Let us know what you come up with.


    Sent from my iPad using Tapatalk HD
    Join http://scopeny.org/ Shooter’s Committee on Political Education

    The world is full of sheep,try not to join the flock.

    Support the Skilled Trades, Don't DIY

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event