Need more info.
I have red blinking light and code 2 flashing. I reset but works and stop in harvest mode.
Need more info.
Does the machine produce and drop ice in harvest before it shuts down. How long does it take. How is the water level. is the unit clean.If it shuts down after it drops ice or during ,just clean the eyeballs.They are on either side below the ice grid.Take side panels off.A 2 flash i think is refrig,diagnostic.It will lockout during harvest if no ice is seen dropping by the eyes.I call them eyes. I forgot what they are actually called.&5% of the time, ice machines shut down due to in-sufficient maintenance
R I P Icemeister
Supporting our Vet’s
http://www.soldierride.org/
http://www.woundedwarriorproject.org/
I just cleaned the unit a month ago. It will get to harvest mode and operate in harvest maybe 3 minutes and unit will go into alarm mode. I just pulled the water level sensor, and the water temp sensor to clean. I just replaced the water filter also and the unit ran for two cycles and went back to code 2. I didn't see the eyeballs. This unit just have the curtain with a sensor telling the motherboard the ice dropped. I will look again for them. I received a bin full code once after a cycle but the bin is empty. I looked for the sensor in the bin but undetected. Water level is good. Should I run the cleaning solution through the system ?
Yeah, a prodigy won't have bin eyes If it didn't doesn't drop ice within three minutes, i think it will lock out. If it is dropping, you have a bad curtain switch
Ok, Thank you
Is it harvesting within that three minute time?
The meaning of the code should be listed on the door, I can't remember what they are offhand. If the magnetic switch on the curtain was bad, I don't think it would even start a cycle, thinking the bin was full. Check the thickness of your ice, it may be too thick or freezing over to the sides of evap or even to ice probe itself.
Check the bin switch by opening and closing the curtain while watching the light on the board.
Yeah, I think so, everything they need to know is on the label on the door,,, in english,, The rest is just common sense.
I checked all sensor leads with a meter an each had continuity. Door switch was good by watching the sw2 light as I open and closed the curtain. I'm still getting code 2. The label say harvest retrying for the code. I'm during another cleaning since it's been a month.
Call your local Scotsman service rep.
Sent from my iPad using Tapatalk HD
Every customer you take for granted today will be someone else's tomorrow.
You can find that local service dealer here:
http://scotsman-ice.com/?xhtml=xhtml...xsl=locate.xsl
Sent from my iPad using Tapatalk HD
Every customer you take for granted today will be someone else's tomorrow.
I'm located in the indian ocean on an island named diego garcia. No service tech allowed here but thanks anyway.
Well our rules prevent DIY advice. Your best bet is to download the manual or call Scotsman direct.
Sent from my iPad using Tapatalk HD
Every customer you take for granted today will be someone else's tomorrow.
Yeah sounds D I Y as the info us on the inside cover. The machine is getting old and with age goes their vision if you know what I mean. Haha I always love showing up on the call with that black diverter put back in so many creative ways. Scotsman are alright but you will never compete with the Cadillac of ice machines: Hoshizaki