Page 2 of 2 FirstFirst 12
Results 14 to 19 of 19
  1. #14
    Join Date
    Aug 2012
    Also, he told us that we could remove the cover, unplug the air handler, and reverse the black and blue wires to up the speed back to full. I opened the cover and reversed the two wires, but one was called M1 or M2 and the other one was attached to a small fan that looked like an exhaust fan, leading to a rooftop exit. So I put them back to the way they had been. Plus, I didn't hear any increase in air velocity.

  2. #15
    Join Date
    Jan 2004
    think you got the wrong wire.
    Contractor locator map


    How many times must one fix something before it is fixed?

  3. #16
    Join Date
    Dec 2011
    San Antonio, TX
    Please be careful moving wires around!

    Without knowing external static pressure, no one can tell you yes/no about the fan speed.

    It is possible the blower is pushing water off the coil and into the plennum if its a gas fired furnace. Simple to fix but rules do not allow us to post DIY info.

    Did the tech measure air flow before and after moving the fan speed? Did he blow out the drain before pouring water into it? Did he check the drain where it connects to the plumbing? Did he pour water into the trap or the pan?

    If not, find a qualified tech in your area to come out. If your plan doesn't cover the service call, pay out of pocket. A collapsed ceiling is no joke and will cost a lot more.

    Please be careful about moving wires around!

    Sent from my ADR6350 using Tapatalk 2

  4. #17
    Join Date
    Aug 2012
    can you give general guidelines on what the proper solution is? If it's simple, shouldn't the tech have figured out what to do? I still am not sure if I should leave the fan at 1/2 speed or if I should want it to be blowing full speed. Thanks.

  5. #18
    Join Date
    Jul 2006
    In Phoenix you want all the airflow you can get

  6. #19
    Join Date
    Mar 2009
    Mount Holly, NC
    the fan is not at 1/2 speed, it's only reduced by 1/3 or 1/4th.
    I would call the tech/home warranty company and ask if cleaning the coil/blower was done? a partially obstructed coil will cause air to be forced through the coil at a higher pressure, and this can blow water into your ductwork.
    The TRUE highest cost system is the system not installed properly...
    The three big summer hearththrobs...
    Mel Gibson
    Dwane Johnson
    The A/C repairman

Page 2 of 2 FirstFirst 12

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event