19XL retrofit to PIC III - Page 2
Page 2 of 2 FirstFirst 12
Results 14 to 17 of 17
  1. #14
    Quote Originally Posted by freonrick View Post
    looks good, did you have to change motor and bearing temp sensor?
    No need!
    Can

  2. #15
    I only buy the control panel actuator and ISM and modify the control wiring for the power box and starter by myself! The cost will most cheaper!
    Can

  3. #16
    Quote Originally Posted by budglo View Post
    Nice job.I have done 6 retrofits . Threee 19xls with r-22 and 3 19xrs with 134a.I have yet to use that huge panel that comes with the relays and ISM module.I ended up gutting the low voltage side of the starter and using the space for the new components.All in all they have turned out pretty good.Everyone seems happy with it and have not had any problems.
    I only buy the control panel actuator and ISM and modify the control wiring for the power box and starter by myself! The cost will most cheaper!
    Can

  4. #17
    Quote Originally Posted by Octopus View Post
    Very clean, nice job can. Fyi those old controls are worth some money.
    Thank you very much!
    Can

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event