Teletrol 186 info needed

[Failure2Comply]

I ran into an old Teletrol 186 Integrator today that is has the "error light" on solid. They lost their building's transformer and now the system will not run. There is no information on site about this system. Does anyone have any info or manuals for this system?

Recently their old GE/Fuji freq drive blew its top so we put in a Johnson Control freq to get them back up. This is an old Marlo hot deck/cold deck system but these people do not have a lot of money as they are a low profit organization that helps people.
Thanks,
John

[klrogers]

I ran into an old Teletrol 186 Integrator today that is has the "error light" on solid. They lost their building's transformer and now the system will not run. There is no information on site about this system. Does anyone have any info or manuals for this system?

Recently their old GE/Fuji freq drive blew its top so we put in a Johnson Control freq to get them back up. This is an old Marlo hot deck/cold deck system but these people do not have a lot of money as they are a low profit organization that helps people.
Thanks,
John

Put your email address in your profile and I will send you some info. Where in VA are you?

Kevin

[Failure2Comply]

I am in Chesterfield Co.
Thanks,
John

[Failure2Comply]

Thank you for the manual and information.
John

[air j]

Do you have a installation manual for the teletrol integrator 186. I want to hook up a laptop with a local (direct connection) but I must be doing something wrong I get an internal error. Any help would be greatly appreciated.

[Denhvax]

I sent you a network installation manual. Hope it will help.

[apprentice3]

I sent you a network installation manual. Hope it will help.

I was just curious.. With those old Teletrol Integrator 186 panels don't you need the site database in order to connect and see the points or is there a upload command that you can extract all of the programming? I know typically I get the database added to my computer before I connect.

Thanks!

[DDClifer]

If the error light is on, the program is most likely flushed out, which would mean you wouldn't be able to see any points or data. There was no way to upload the program from those controllers. The program was held by a li-ion battery (looks like a AA, but isn't). If the battery was dead & you lost power, you also lost the program.

[ddeuel]

I know this thread is pretty old, but our 186 Integrator lost power and seems to have reset to defaults. I am trying to find the default password so I can upload our control program to it. Is that information in the manual? Thanks!