Page 2 of 2 FirstFirst 12
Results 14 to 15 of 15
  1. #14
    I have the same 5410 machine as that. Been working fine and staying out in the drafty garage... until a couple weeks ago. The little round pin which goes in the coupler between the motor and pump worked its way into the pump shaft bearing and then out. Easy fix with a little epoxy added for good measure. Was a good time to clean up the grime and dead bugs in there while it was apart.

  2. #15
    Join Date
    Jun 2007
    Location
    Darby, PA
    Posts
    526
    Just got a new G5 Twin today! Boss had to replace two this week. Now my back thanks him, a little less stress during the day.
    Psalm 51:10, 12

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event