Trane zone sensor

[jammzzville]

I have a Trane programmable zone sensor. Model BAYSENS119A connected to a YCD360 (can provide full model # if need be) After configuring the sensor, "E1" and "E2" flash on the screen. In the manual for this sensor there is no E1 or E2 error code listed in troubleshooting. Just E0, E6, E7, and E8 are in the manual but no E1 or E2.

Does anybody know what these error codes correspond to?

Thanks very much.

[hvac69]

According to Trane Lit http://www.trane.com/webcache/es/bui...n_06302010.pdf
E1 heat failure
E2 cool failure

[tuba]

Thank you! I was looking all over the place for this.

[gwoner]

The guide setup does'nt contain the info you need. You need the I.O.M. liturature, shows everything including E3 and E 4 faults, also CV,HP and VAV setup configurations.