Page 2 of 2 FirstFirst 12
Results 14 to 16 of 16
  1. #14
    Join Date
    Aug 2011
    Location
    York, PA
    Posts
    157
    I would like to try the copper tubing, how do they attach the copper to keep it firmly in place? It has been a few months since I looked in the sump, but I believe the wires are just zip-ty'd to an oil line in there. There is no stress on the wires at the terminals or the sensor.

  2. #15
    Join Date
    Mar 2008
    Location
    philadelphia
    Posts
    337
    http://www.totaline.com/dl/RCD-3519-060.pdf Check out page eight.
    http://www.grainger.com/Grainger/CADDY-Pipe-Strap-1RUW1 The tubing supports look like this but i prefer the ones with the rubber on them for vibration. 1/2" O.D. tubing should be fine, Carrier would flare the ends to keep the edges away from the wires should be fine.
    If you look in the cuts you can see this and also they would have a support of the oil feed to the high speed.
    Hope this helps

  3. #16
    Join Date
    Aug 2011
    Location
    York, PA
    Posts
    157
    Yes, def helps. We'll try this during shutdown this winter. Thanks!

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event