We are currently converting one of our customers from an old Metasys PMI setup with NCs to FX60s and FX70s with FX Server at the front. While doing some graphic work, I came across a little problem. In the past, when using a single FX60/70, I have programmed one graphic's data fields to represent multiple VAV/CAV boxes, Fan Coils, etc. by entering the ord like "slotoints/Occupancy/out/value". I then assigned the graphic to the controller. So, when navigating the VAV graphic, once you click on a particular button assigned to a VAV controller, the VAV graphic pops up and the point fields get filled with that controller's data. My issue is that I cannot make this happen using the FX Server. Since the points map to the FX Server as one large pool of Niagara points, I cannot setup the ords the same way. I am not an FX Server guru and cannot figure out the proper ords. I started to generate an individual page for each FCU, but there has to be a way to do it with the Server that I don't know about. If not, I will wind up with a hundred VAVs and FCUs. This is such a common use of the ords that hopefully someone has run into this before and can help me out. Thanks for the time.