HOA indication on FEC? any clever solutions?

[nasaguyjoe]

Need to wire up a position indication of an HOA switch to an FEC. Any clever ways of doing it other than two BIs? Still new with programming these. On andover I'd just use an AI point with different resistors on the positions and do an If/Then statement. Not sure what to do on the FEC....

Thanks in advanced!!

[sycontrol]

that should work with jci as well.

[nasaguyjoe]

So there is an If/then block? I haven't done any programming on them beyond the standard tree selection program builder and tweaking those slightly.

Hope to be taking a class in July.

[sycontrol]

Although I haven't tried it. It should be doable. You would have to do a little custom programming.