Results 1 to 4 of 4
  1. #1
    Join Date
    Jun 2010
    Location
    New Orleans
    Posts
    75

    HOA indication on FEC? any clever solutions?

    Need to wire up a position indication of an HOA switch to an FEC. Any clever ways of doing it other than two BIs? Still new with programming these. On andover I'd just use an AI point with different resistors on the positions and do an If/Then statement. Not sure what to do on the FEC....

    Thanks in advanced!!

  2. #2
    Join Date
    May 2011
    Location
    North Carolina
    Posts
    257
    that should work with jci as well.

  3. #3
    Join Date
    Jun 2010
    Location
    New Orleans
    Posts
    75
    So there is an If/then block? I haven't done any programming on them beyond the standard tree selection program builder and tweaking those slightly.

    Hope to be taking a class in July.

  4. #4
    Join Date
    May 2011
    Location
    North Carolina
    Posts
    257
    Although I haven't tried it. It should be doable. You would have to do a little custom programming.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event