What nut setters

[FrostyBeer]

WTF is a nut setter? LOL

Just head over to your local "toy" shop and they'll help you out.

[hvacrmedic]

I keep a set of these, usually in my pocket. I don't know how I ever got by without them.

http://www.homedepot.com/webapp/wcs/...5f%2d202279618

[jpsmith1cm]

I keep a set of these, usually in my pocket. I don't know how I ever got by without them.

http://www.homedepot.com/webapp/wcs/...5f%2d202279618

I've had my eyes on those for a while, now.

I've dealt with too many universal joint type thingies that bound at certain angles, though. Do these do that or is the angle limited to a point where it cannot bind?

[drew2128]

WTF is a nut setter? LOL

For every day stuff, I carry 6" x 1/4", 5/16", 11/32", and 3/8". I'll probably take the 11/32" out of the tool bag. The only time I ever used it was on fractional HP condenser fan motors, and I haven't done one of those in at least 4 years, lol.

What would you call them then?

What do you call the nut driver bits and the nut drivers with handles?

Thats why I call them nut setters so you dont confuse the two.

[KCJN832]

I keep a set of these, usually in my pocket. I don't know how I ever got by without them.

http://www.homedepot.com/webapp/wcs/...5f%2d202279618

I have been using these for over a year! I just about can't function w/out them. I keep an 11/32 Nut Driver (Notice Proper Use of Name ) in my instrument case, for motor replacements. The 1/4 wobble goes in my impact and the 5/16 wobble goes in a 6" Irwin extension in my Rear Guard Pouch, Best tool belt ever! Makes climbing thru scuttle holes possible.
http://www.google.com/imgres?hl=en&c...r:12,s:0,i:113

[KCJN832]

WTF is a nut setter? LOL

For every day stuff, I carry 6" x 1/4", 5/16", 11/32", and 3/8". I'll probably take the 11/32" out of the tool bag. The only time I ever used it was on fractional HP condenser fan motors, and I haven't done one of those in at least 4 years, lol.

Wiki Definition:
The device your wife uses (when she finds you cheating on her!) to cut off, flatten and then shove your nuts down your throat.

[hvacrmedic]

I've had my eyes on those for a while, now.

I've dealt with too many universal joint type thingies that bound at certain angles, though. Do these do that or is the angle limited to a point where it cannot bind?

They don't bind in the slightest. They do sometimes snap into the straight position on you when you're trying to manuever them onto a screw head with one hand. As they wear in that isn't as much of an issue.

[hvacrmedic]

Screw behind the line set, no problem.