mitsubishi lm adaptor integration

[clynn]

Has anyone integrated the mitsubishi with a jace (trend TONN6)? Im having some problems with this system.

[Keith D]

I have not done a Mitsubishi integration but have done a few others.
I have worked with Tonn,Hawk & Jace. I may be able to help.
What exactly is the problem?

[clynn]

We have done daikin and Sanyo, but this our first Mitsubishi. I just can't pull in any points and the lm adapters keep freaking out, and Mitsubishi tech is about terrible in helping out.

[Keith D]

Have a look at the Lonworks help file in workbench.

It has some usefull pointers to the 'Lon Utilities Manager' this may help you identify a timing issue perhaps.

Also have a look through the 'About Lon Network Architecture' in the same help file. There are some good pointers in this which may help you.

I take it that you can see the devices on the lon network when you do a learn. but then you cannot discover the Nv's & Nc's of each device.

Do you have a lon adaptor in your laptop? if so then try and run up a station on that and connect locally, try the learn process again. If it works then it could point to a wiring issue.

Just a few thoughts.
Keith

[clynn]

yes, you are 100% correct. I did that over the weekend and got all my points pulled in and everything working correctly. Thanks!!

[Doug-e-fresh]

yes, you are 100% correct. I did that over the weekend and got all my points pulled in and everything working correctly. Thanks!!

You may want to look at this site as well to make sure. I just did one and I was able to see everything but to prevent local setpoint control and scheduling the documentation is essential.
http://usa.mylinkdrive.com/categorie.../show/538.html

It is the Mitsubishi Site for their LON interface.