Results 1 to 2 of 2
  1. 10-29-2012, 03:43 PM #1
    George S
    George S is offline Regular Guest
    Join Date
    Jul 2012
    Posts
    7

    Trane Tracer Panel and ZN517

    I have no experience with Trane Tracer Panel. I have to controllers on the network, 2 ZN517's, one is communicating properly. The first thing I did was to reset the problem ZN517, it did not come back onliine. I tried a rebind, that did not help either. I put the Tracer panel to look for other devices, then I hit the service pin button, the panel did discover the ZN517. This tells me that the communications wires to the controller are good (I think). Is there something else I could try to get this device back online. I don't have any Trane software.
    Reply With Quote Reply With Quote
  2. 11-04-2012, 08:37 PM #2
    tescontrols
    tescontrols is offline Regular Guest
    Join Date
    Nov 2012
    Location
    Florida
    Posts
    11
    You are correct in assuming that the comm wire is good.
    It also looks like you do have at least Summit software since you were able to identify the device. You might want to check in your tools tab and see if you have rover available.
    Also, after you identified the zn did you unassign, save, then reopen assign and save?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules