Excuse me if my english is not pretty clear...
we have in mi job yesterday a black out and now...I turn on the metasys
program cause the pc went out with the black out...
but i noticed that there are not the Bacnet and IP icons in the object area from
the program so...when I tried to see the data of one RTU there´s none only
i turn off and on the metasys main module... i checked the communication cable
when disconnected from the PC...I have a message that the cable was remove
So what can i do now ?
You should try the controls forum...
Is your system still operating, your just not able to monitor it?