Oh !!! was all I could say when a drain pan from a Heatcraft LSC-208 slipped and drenched my H10PM in a walk-in today.

I mean it got a direct hit with maybe a pint of water still laying in the pan after I had drained it. I had intended to gently lower the pan down but the RH end got hung up on a dang door buzzer thingy hanging there.

Fortunately it was turned off at the time, but the cover was wide open. I dumped the water out as best I could and knew not to switch it on after all that water. I used my D-Tek Select to finish the job while the H10 sat outside in the sun. I'm going to put it in the oven tonight set on 140ºF to get it dried out throughly. (That's worked for my cellphones)

Any bets on the outcome?