Results 1 to 2 of 2
  1. 04-11-2012, 07:36 PM #1
    ndk1911
    ndk1911 is offline Professional Member
    Join Date
    Feb 2012
    Location
    PA
    Posts
    27

    YCAS with DXS compressor..motor terminal seals

    I had a heck of a time replacing some motor terminal seals(the o-rings under the insulators) today, anyone have some advice on making this process less of a pain in the a*$??
    Reply With Quote Reply With Quote
  2. 04-11-2012, 08:49 PM #2
    drivewizard's Avatar
    drivewizard
    drivewizard is offline Professional Member*
    Join Date
    Dec 2003
    Location
    Half way between North pole and Equator
    Posts
    921
    If it was easy.....
    ya, it is kind of a pain. I found it is easier to pull the suction cover, but you have to move the comp to do that.
    If you don't want to do that, then get some seal picks and pull the seals up with them. That actually works pretty good.
    You can do the motor terms with out removing suction suction cover, but if you have to do the temp sensor terminals I would recommend pulling cover.
    “If your work speaks for itself, don't interrupt.” ~Henry J. Kaiser
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules