Results 1 to 3 of 3
  1. #1
    Join Date
    Feb 2010
    Location
    NE Alabama
    Posts
    301

    Hobart AM15T ml 130039

    Looking for the answer to what the P1, P2, and P3 service codes are related to. I have been into the programming and when I remove the code it comes back even though the machine is operating properly. 2 weeks ago I canceled the code and it stayed gone until the middle of this week. Doesn't seem related to a probe so far. Any help would be appreciated.

  2. #2
    Join Date
    Mar 2008
    Location
    Over the river and through the woods
    Posts
    116
    P codes are code errors. If they keep coming back and your probes are all good, the board may not be keeping it's configuration in its' memory correctly.

  3. #3
    Join Date
    Feb 2010
    Location
    NE Alabama
    Posts
    301
    Thanks for the confirmation there chrldwlf. that was where I was in my diagnosis too. I told the customer to ignore it until the wash/rinse cycle starts to break down.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event