Results 1 to 3 of 3
  1. #1
    Join Date
    Feb 2010
    Location
    NE Alabama
    Posts
    301
    Post Likes

    Hobart AM15T ml 130039

    Looking for the answer to what the P1, P2, and P3 service codes are related to. I have been into the programming and when I remove the code it comes back even though the machine is operating properly. 2 weeks ago I canceled the code and it stayed gone until the middle of this week. Doesn't seem related to a probe so far. Any help would be appreciated.

  2. #2
    Join Date
    Mar 2008
    Location
    Over the river and through the woods
    Posts
    120
    Post Likes
    P codes are code errors. If they keep coming back and your probes are all good, the board may not be keeping it's configuration in its' memory correctly.

  3. #3
    Join Date
    Feb 2010
    Location
    NE Alabama
    Posts
    301
    Post Likes
    Thanks for the confirmation there chrldwlf. that was where I was in my diagnosis too. I told the customer to ignore it until the wash/rinse cycle starts to break down.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event