Results 1 to 8 of 8

Thread: trane 60 ton

  1. #1

    trane 60 ton

    I hope someone can assist me

    Im currently working on 2x trane RAUJC60E units .. and at pressent they aint responding to a thermastat call for cooling . having checked and double checked we have traced the electrical circuit back to the high pressure sensor in one unit and the low prssure sensor in the other?? there are no broken wire on the sensors and I have replaced one sensor with a new one.. and still the problem, again through the circuit shows it is the sensors in both units..are not allowing the breakers to pull in?. can you advise on how I can equal the presure ? resolve !!! so it will start the compressors?

    any advise will be gladly accepted..
    regards
    darren

  2. #2
    Join Date
    Feb 2006
    Location
    Phoenix,AZ
    Posts
    2,874
    I doubt you will get much help as "breakers" do not "pull in"! But anyways, is your evap fan running?

  3. #3

    trane unit

    it appears that the fans will run with the compressors once i kill the power then switch on again. then after 10mins ckt1 will shut down. leaving ckt2 running

  4. #4
    Join Date
    Jul 2007
    Location
    The Hot South
    Posts
    1,310
    Dazza

    It's obvious that you are not a tech due to your comment that "the breakers won't pull in". Read the site rules at the top of this page about no DIY.

  5. #5
    Join Date
    Feb 2012
    Location
    EVERYWHERE
    Posts
    228
    It is the lockout circuit that is keeping it off. You might better get someone out there that knows it or call Trane.

  6. #6
    Join Date
    Aug 2006
    Location
    Columbus Ohio
    Posts
    1,980
    Call an actual company to fix your equipment or obtain pro status here before asking DIY questions.
    UA LU189

    10mm, because it's better than .45acp

  7. #7
    Join Date
    Dec 2002
    Location
    Arizona
    Posts
    4,356
    Quote Originally Posted by zw17 View Post
    Call an actual company to fix your equipment or obtain pro status here before asking DIY questions.
    Maybe when he gets to Pro status he can teach us about those special breakers!
    Make your expertise uniquely valuable.

    Make your influence uniquely far-reaching.

  8. #8
    Join Date
    Nov 2006
    Location
    Southeastern Pa
    Posts
    18,260
    I always wanted a breaker that could pull in....
    [Avatar photo from a Florida training accident. Everyone walked away.]
    2 Tim 3:16-17

    RSES CMS, HVAC Electrical Specialist

    AOP Forum Rules:







Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event