Search:

Type: Posts; User: browntrout

Search: Search took 0.00 seconds.

  1. Oh sorry buddy.. that for 4-20 to 0-10VDC I read...

    Oh sorry buddy.. that for 4-20 to 0-10VDC I read your post wrong
  2. I use a 500ohm and just go across the two wires...

    I use a 500ohm and just go across the two wires at the device that is controlling the device.One side on positive one side on negative. If that makes sense. Works everytime. Also this will not work...
  3. Replies
    9
    Views
    1,483

    Hey thanks guys! So if i buy the Envision is that...

    Hey thanks guys! So if i buy the Envision is that backwards compatible so I could see and program all my device? If so what else would I need to connect. Software key? Also we didnt install this,...
  4. Replies
    9
    Views
    1,483

    Alerton Controls

    Hello,
    Im new to Alerton, I have several sites that have older Alerton controls. I devices installed are SA-651, TX653P, I believe a Microview or LANview and a TX-APLC. I need to know which of...
  5. Replies
    11
    Views
    1,426

    Thanks for the input! Looks like it will be super...

    Thanks for the input! Looks like it will be super duper ugly mallron. No back up no reboot and no luck. Also Im not actually in WV any more. Transferred out west. Id like to just do away with the...
  6. Replies
    11
    Views
    1,426

    Yea it will not go away now. it was clearing...

    Yea it will not go away now. it was clearing after you cycle the power but now its also giving a error of failure in power reboot, cycle power. Neither one will clear. How to i find out what parts to...
  7. Replies
    11
    Views
    1,426

    I haven't actually hooked up to it with anything....

    I haven't actually hooked up to it with anything. The error code I got is off the controller readout. I think it was like 7? And it says it means boot load fail. I was just wondering what that ment?
  8. Replies
    11
    Views
    1,426

    There is no Pc on site they have siemens for...

    There is no Pc on site they have siemens for there controls this is just controlling the chillers. there is no ethernet wire leaving the BCU. My main concern is the error of boot loader not found. I...
  9. Replies
    11
    Views
    1,426

    Trane Tracer Summit

    I need to connect to the Tracer Summit controls. Model BMTW I have the tech view service tool version 14.0. is this what I use to connect and if so what cable is required? Im getting a reoccurring...
Results 1 to 9 of 21
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event