Search:

I was rereading the origonal post and noticed one more small thing that needs to be done.

You need a jumper between W1 and W2 if you are not going to have more conductors run.
With the jumper in...

nitrogen should be purged through while brazing a piece of pipe in place of the old factory filter drier and while brazing in the new filter drier outside the unit.

[B]

The filter drier needs...

Ignore the "note 9", it doesn't apply to the XL16i because of the way the airflow is controlled.

A jumper from R to O would serve the same function as a jumper from Y to O in your case. I prefere...

While that is a concern, since it is a new system with new refrigerant lines, and there was purging and pressure testing with nitrogen, I doubt that more moisture got into the system than the filter...

It is highly unlikely that the compressor was damaged in this short of a time, so I wouldn't worry about it to much. Just make sure they do everying I mentioned in my last post.

Did you get a 10...

Your control wiring is still not correct. The XL16i wires differantly than the instructions with the furnace indicate. The instructions with the furnace have not been updated since the XL16i came out...