Search:

Not Bacnet, all V2- All the controllers on your navigator pane are programmable "micro" controllers- only a few of us left that know that protocol really well- message me if you want further V2 help

ME TOO only at Your email address IS in your profile

Hi, I too could use that software!!! Email in profile
TIA!!!!

1. What percentages of jobs have included Modbus?
10%

2. What percentages of jobs have included Lonworks?
20%

3. What percentages of jobs have included BACnet?
98%

4. What percentages of...

you should have two Coax connectors on each panel. one connector should have a "cap resistor" on each panel, the other connects to the other panel. you should be able to do a D CPX (x being the other...

how about "Goesinta" and "Goesouta" :D

Nope, Igraph will not access V3 panels. The V2 (intellicon's) had a Terminal emulator, V3 does not

Help is in your Email!:oops:

Email me, My email is in my profile

WOW, You going back a few years!!!! Only the "OLD" Delta partners would even recognize this.

You need to save the database, then run it thru dbstats.exe to get rid of the Corrupted sections, If...

I used these at a LEED site, works great!

Global Water Instrumentation, Inc
http://www.globalw.com/catalog.html#weather


Call (800) 876-1172

These have worked great. the only issue was a viconics stat that was LON, labeled as bacnet

Does the rest of the net-work properly?

Also, did you try isolation just to this one device?

You are correct- DSC-633 is an OEM product (Real time clock on a DAC-633)
it should integrate well to your Jace.

got a qoute and tested them for 30-40 miles line of site.

http://www.spinwavesystems.com/productoverview.htm

Yes, TAC service is correct aesthetics is 80% of the job...
Only problem again with my above mentioned project. The had these light dimmers attached, when the system died, no lights, part of the...

My post was from prior experience, the Energy company provide a pre-enginnered product, it went in ok, installation was ok.. then the failures... 50% failure rate on equipment, blame laid on...

If you do not mind having your name associated with "junk",
Go Ahead... the money is good till you are blamed for all of the deficiencies.

I have two of these installed and working

http://www.globalw.com/products/we300.html

Also, they had a better price on weather stations. All of the products have held up nice

Thinking of The "right"side of California?
Sacramento is Capitol!

On older sites , I VNC/Remote desktop/PC anywhere into my desktop at the office with Modem. There are a lot of remote control possibilities

Do that with my Verizon card anywhere

Thanks for the reply.. I finally got a cut sheet on the correct sensor (TSP-90130)

See attachment

its got a heating and cooling slide switch

Either way, I will contatc ACI

Thanks again

Anyone know of a company replacing the TS9000 series? I have sensors that are dying Model number TS90130?

Thanks

ALL product uses similar Sram chips... it seems to be the DAC product hit hardest, but I have seen it in DSC's as well

looking for a Controls tech/PM to work all over Northern California,
Bay area or Sacramento based OK.


competitive wage DOE
full time with benefits
Company truck
EOE

Clean DMV required

http://www.hvac-talk.com/vbb/showthread.php?t=142666&highlight=delta

Delta had a Sram issue that was marginal from the manufacturere of the chips, the chip set was run from 2004 to early 2006
...