Search:

We have had 3 geo systems that after running about 9 months to 1 year on a pressureless system all of a sudden overflow fluid from the QT center, we have flushed them with the flush cart until all...

Thank You cmajerus

Worked on old quaker oil stove today and oil regulator not working properly. Model #HB4308D60. S#37914. Is there a company out there that still sells this type of equipment. I want to replace this...

If it would stop a leak why would one not like it? Is it harmful for compressor?

I have a customer with a refrigerant leak in his lineset which is in a wall which goes up 3 stories to an evaporator in the attic. I did an isolation test on system to determine that leak was there....

What are the reasons for a compressors internal overload to open?

sublimation was the term i was looking for. Thank you

very funny everyone, but i still haven't seen an answer. LOL

if one were to change 32 degree ice to a vapor, what is the term used to describe this?

I went on an oil furnace maintenance a couple months ago and serviced system. Routine maint.. I don't have my readings in front of me right now to tell you but everything was running and ok. ...

furnace approximately 8-9 yrs old

filters are clean, vents open. Bard furnace, I don't have the model and serial # at this time with a becket burner, I believe the model was AG but I am not certain.

Oil furnace no.2 fuel oil. What would a normal stack temperature be, what would be considered too high or too low? If too high what would be causes and if too low, causes. I have been told between...

Am I not asking the question right?

What causes the high voltage reading across the terminals of a run capacitor??

been up for 7 days

units been on for 3 7 days, bulb is not insulated. I am having this debate in another post about the insulated txv. That post was from today, go ckeck it out. I think that is the problem too

[QUOTE]Originally posted by beenthere
[B]With a txv, if you take your indoor wetbulb, you know what your keaving drybulb temp should be.

Does it get to set point but continue to run, or is the...

indoor wet bulb not taken because txv metering device, od ambient 85-90, I took coil delta but i'm not sure what it was at this time, complaint is unit not shutting off

go to my earlier post to get that info, thanks

then why does my suction pressure never move, do u think the the TXV could be stuck open and refrigerant is free flowing through coil??

inside the plenum or inside the coil case what is the difference, because i don't understand

it was not a cased coil. sheet metal was built around the coil, thats what i call the plenum, am i incorrect?????

final answer

Does a TXV bulb need to be insulated if it is inside the plenum on the outlet of the evaporator?? I have a new replacement that has low cooling and the unit runs all the time. I spoke of this unit...