Search:

Type: Posts; User: bananapeal

Search: Search took 0.00 seconds.

  1. Replies
    5
    Views
    667

    Resolution was to turn the three way 90 degrees...

    Resolution was to turn the three way 90 degrees so that 2 ways point to the windows and far wall while the third right up against near wall. Back of register to return. At least no more obvious...
  2. Replies
    5
    Views
    667

    Thank you for your replies. I have asked for a...

    Thank you for your replies. I have asked for a one or two way, they said "we'll see" and wants me to wait until it's all hooked up. But they've been running it all day and just with partial...
  3. Replies
    5
    Views
    667

    Is it possible that there is indeed no issue with...

    Is it possible that there is indeed no issue with the return being so close to the supply?
  4. Replies
    5
    Views
    667

    3 way supply and return placement

    I have selected low bid work because they did my friend's place and he had nice things to say about them.

    They are here now and have finished placing the upstairs in-ceiling supply/return...
  5. Replies
    15
    Views
    1,836

    Yaay for subsidies! Where would we be without...

    Yaay for subsidies! Where would we be without crop insurance, flood insurance, rural airports, and gov't discounted geothermal pumps and Chevy volts?

    It's only in consideration because after tax...
  6. Replies
    15
    Views
    1,836

    had 2 "professional"-er contractors today. One...

    had 2 "professional"-er contractors today. One guy spent an hour and a half over and measured everything, the other guy measured just some windows and spent 30 minutes. They both have nice reviews on...
  7. Replies
    15
    Views
    1,836

    Hello again! Every night at around 6-7pm...

    Hello again!




    Every night at around 6-7pm when it's cooler outside than in, I run around the house and open up all the windows. In the morning we close them all up and hope the insulation...
  8. Replies
    15
    Views
    1,836

    Thank you all for your replies! I hope it...

    Thank you all for your replies!



    I hope it wasn't too long-winded!

    I was loosing hope that there were any contractors out here that would do a load calculation. I did find a guy in hartford...
  9. Replies
    15
    Views
    1,836

    Contractor attitude

    Good Afternoon Folks, :putergreet:

    This is my first post after reading here awhile. Therefore, I think I know in which way your advice might go. I have a 2600sq ft 5 year old colonial.

    I've...
Results 1 to 9 of 9
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event