Search:

Type: Posts; User: mud

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    10
    Views
    629

    The capillary tube is usually soldered to suction...

    The capillary tube is usually soldered to suction line. That is the heat exchanger referred to


    Sent from my iPhone using Tapatalk
  2. Replies
    5
    Views
    338

    I know we had a machine on start up with with a...

    I know we had a machine on start up with with a couple issues one being a hot gas valve. That machine could not be put in manual harvest and the board was replaced per tech support


    Sent from my...
  3. Thread: Nest

    by mud
    Replies
    18
    Views
    1,401

    Nest

    I had one short out as well. Customer had installed it a week earlier. Short outside by the condenser caused the thermostat not to power up the O terminal. Unit had been working properly until they...
  4. Replies
    7
    Views
    879

    Well the performance sheet at the highest (140°...

    Well the performance sheet at the highest (140° cond 15° evap) shows 6.7 amps so I wouldn't think it should open at 6.2 unless there is alot of heat or it is weak. And if it is running at those...
  5. Thread: Trane RTU

    by mud
    Replies
    15
    Views
    1,188

    And once upon a time didn't Trane want there info...

    And once upon a time didn't Trane want there info taken off the site. Saves some trouble sharing outside the open areas. Just sayin!
  6. Replies
    10
    Views
    1,178

    I've only had one unit that busted a pilot tube...

    I've only had one unit that busted a pilot tube more than once. 2 times within a couple months or something like that. I went out to do the 2nd and found poor connection causing a chatter. Can't...
  7. Replies
    17
    Views
    1,789

    I'm always willing to help someone learn. I'll...

    I'm always willing to help someone learn. I'll part with a brand new 1/2hp for $6000.
  8. Replies
    12
    Views
    5,456

    http://www.trane.com/Residential/Products/Packaged...

    http://www.trane.com/Residential/Products/Packaged-Units/XL16c-Heat-Pump-Packaged

    here's a 16 SEER resi unit
  9. Thread: Music sites

    by mud
    Replies
    9
    Views
    576

    Assuming it was a typo DRM digital rights...

    Assuming it was a typo DRM digital rights management

    http://en.wikipedia.org/wiki/Digital_rights_management
  10. Replies
    7
    Views
    973

    forgot the .com that time ...

    forgot the .com that time

    http://www.hvacrinfo.com/Tecumseh_bulletins/model.pdf
  11. Replies
    16
    Views
    2,776

    To check for hot water entering the machine due...

    To check for hot water entering the machine due to bad mixing valve I've always just made a point to be there 1st thing with whoever unlocks the place to make sure its not getting hot water then....
  12. Replies
    2
    Views
    710

    The slaves just wont have a temp control and...

    The slaves just wont have a temp control and solenoid. If I understand correctly all 3 evaps are in 1 box. If that is the case they should all have heaters.
  13. Replies
    12
    Views
    852

    Your looking for 60hz equipment?? Found a Fujitsu...

    Your looking for 60hz equipment?? Found a Fujitsu distributor in the UK but the specs I saw was 230v 50hz
  14. Replies
    10
    Views
    3,001

    I remember being told those danfoss valves don't...

    I remember being told those danfoss valves don't need to be wrapped and being able to grab one right after brazing cause it didn't absorb the heat. As far as nitrogen though purge purge purge! Just...
  15. Thread: Help locating part

    by mud
    Replies
    41
    Views
    3,361

    I helped lead someone to a motor that showed up...

    I helped lead someone to a motor that showed up in the shop Thursday. But that guy didn't get fired up when I said we don't normally sell just parts. He was cool about it which made me check it out...
  16. Replies
    6
    Views
    611

    If I understand correctly there is just no wall,...

    If I understand correctly there is just no wall, ceiling, or floor space available for ducts. But if the space is available to mount equipment ductless split may be the way to go. Would not be...
  17. Thread: Help locating part

    by mud
    Replies
    41
    Views
    3,361

    Oh you've heard that too? Anybody else? ::DD:

    Oh you've heard that too? Anybody else? ::DD:
  18. Thread: Help locating part

    by mud
    Replies
    41
    Views
    3,361

    You asked a question and got 1 simple response...

    You asked a question and got 1 simple response that was in no way rude, nasty or out of line. The comment was simply this is not a diy site. After that you showed some attitude and got it back.
    Now...
  19. Replies
    75
    Views
    6,157

    If I suspect a float sticking but working ok when...

    If I suspect a float sticking but working ok when on site I'll cycle the float manually like 100-150 times rapidly and check continuity. Have caught a few that way over the years.
  20. Thread: Help locating part

    by mud
    Replies
    41
    Views
    3,361

    Not always! Had a tough one that took that took...

    Not always! Had a tough one that took that took 10 or 11 seconds the other day. Did I do good though only charged the customer $1.50. I rounded it up to 1 minute because they took awhile to answer...
  21. Thread: Pump Power usage??

    by mud
    Replies
    4
    Views
    485

    my first thought would be kwh is how you pay your...

    my first thought would be kwh is how you pay your bill and so watts should be the same and not much difference in the bill. With that being said I agree the numbers don't make sense. Also not sure if...
  22. Can't speak for other brands but the Fujitsus we...

    Can't speak for other brands but the Fujitsus we have installed have been very reliable.
  23. Replies
    18
    Views
    2,965

    My first thought was crackheads will still get...

    My first thought was crackheads will still get it. They'll just see it from farther.
  24. Replies
    24
    Views
    3,793

    because sometimes as mentioned there are regular...

    because sometimes as mentioned there are regular driers with check valves. Flow is through 1 drier for heating and 1 for cooling
  25. Thread: Frozen up

    by mud
    Replies
    12
    Views
    2,545

    Had one recently they wired 115v heater from #4...

    Had one recently they wired 115v heater from #4 to ground. Noticed it when it went into defrost the fans stayed on real slow.
  26. Thread: Thermostat trouble

    by mud
    Replies
    10
    Views
    1,847

    What are the setup settings for #1 and 3. And...

    What are the setup settings for #1 and 3. And that thermostat should control that unit but there are still some unknowns. Also as stated above only limited info can be given here in the open forum.
  27. Replies
    6
    Views
    541

    I just use the parental control in internet...

    I just use the parental control in internet explorer and then just allow the sites 1 by 1. My daughter is almost 9 and this has worked for a couple years now. Have to be careful though because...
  28. Replies
    16
    Views
    3,898

    There's a couple threads here showing some damage...

    There's a couple threads here showing some damage from that recent storm. Here's 1 http://hvac-talk.com/vbb/showthread.php?t=696651
  29. Replies
    21
    Views
    2,944

    transported makes it sound like it would be...

    transported makes it sound like it would be cheaper and easier to use either an oem or another motor with the right plug. I know that doesnt answer the original question but......

    Or at least use...
  30. Replies
    7
    Views
    2,003

    Yeah but it's always nice to be able to figure...

    Yeah but it's always nice to be able to figure out if they gave you the wrong one.
  31. Replies
    99
    Views
    5,209

    hmmm same thing only on this site but also...

    hmmm same thing only on this site but also only on another computer
  32. Replies
    79
    Views
    20,336

    Well it could be a good thing if the unit is too...

    Well it could be a good thing if the unit is too small. Once its completely trashed the op can get a properly sized unit. just sayin!
  33. Replies
    2
    Views
    434

    warranty was based off factory ship date plus 90...

    warranty was based off factory ship date plus 90 days and that was 12/2000
    so 10 yrs old

    http://www.scotsman-ice.com/?xhtml=xhtml/sct/us/en/general/warranty_verification.html
  34. Thread: TXV PROBLEM

    by mud
    Replies
    47
    Views
    2,987

    Just for kicks i tried to rationalize this...

    Just for kicks i tried to rationalize this but.....

    Looking at a charging chart as wb drops (less humidity) sh goes down
    Thats the opposite as i think they were trying to say

    As ambient goes...
  35. Thread: MajicJack

    by mud
    Replies
    13
    Views
    1,597

    Thanks! working much better now

    Thanks! working much better now
  36. Thread: MajicJack

    by mud
    Replies
    13
    Views
    1,597

    I have been using it for the last couple years...

    I have been using it for the last couple years with no problems running xp. I switched to windows 7 about 2-3 weeks ago and its been real buggy since. I havent had time to mess around with it to...
  37. Replies
    17
    Views
    2,678

    yep changed a few too.

    yep changed a few too.
  38. Replies
    16
    Views
    2,126

    They just wont accept web based emails such as...

    They just wont accept web based emails such as yahoo, gmail etc. cox, earthlink etc will work
  39. Replies
    16
    Views
    2,126

    If your using a web based email (yahoo etc.) they...

    If your using a web based email (yahoo etc.) they wont accept it. I had that problem using my yahoo address and waited for 2 days. Used a cox address and had it instantly.
  40. Thread: Tempstar heat pump

    by mud
    Replies
    7
    Views
    795

    Tempstar sites distributor list says ach supply...

    Tempstar sites distributor list says ach supply in mesa and phx not familiar with them though
  41. Replies
    25
    Views
    3,197

    The 1 i saw doing this the light for the curtain...

    The 1 i saw doing this the light for the curtain switch was a little dim and when the compressor came on it dimmed a bit more then went out after about 10 seconds and shut the machine off. Cant say...
  42. Replies
    25
    Views
    3,197

    I say start with jumping curtain switch Also...

    I say start with jumping curtain switch
    Also have seen a loose fuse on the board vibrate and shut it down
  43. Replies
    45
    Views
    3,769

    What about your buddy who looked at it twice? Did...

    What about your buddy who looked at it twice? Did he tell you where the leak is?
  44. Replies
    2
    Views
    524

    Take it all then bank the extra cash.

    Take it all then bank the extra cash.
  45. To keep it simple I would say a hard start kit is...

    To keep it simple I would say a hard start kit is not going to change starting amps enough that you should skimp on the electrical supply. Thats if I understood the question. As far as weight of...
  46. Thread: Phoenix

    by mud
    Replies
    3
    Views
    654

    Yes really! Shocking huh? :D

    Yes really! Shocking huh? :D
  47. Thread: Phoenix

    by mud
    Replies
    3
    Views
    654

    Phoenix

    We are currently looking for experienced HVAC and Refrigeration techs in the Phx area. All commercial service with an occasional install. If interested send a resume to tj62776@yahoo.com
  48. Replies
    13
    Views
    1,298

    As ice said curtain switch. I bet thats where...

    As ice said curtain switch.
    I bet thats where the ghosts hiding.
  49. Replies
    6
    Views
    625

    as above clockwise colder which will b a higher...

    as above clockwise colder which will b a higher number
  50. Replies
    5
    Views
    1,213

    Have used it a few times but would rather just...

    Have used it a few times but would rather just replace a cap tube. It worked good a couple times and once not so much.
Results 1 to 50 of 199
Page 1 of 4 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event