Search:

Does anybody have any programming code to slave 3 out of 4 vav's. Most of it would be transfers in the global code.

Yes I could try that tomorrow.

Controller VLC SD2A has solid green light on led. It should have a 3 flash instead. I checked MAC address and has correct address on dip switches but still stays a solid green lights. This device is...

The global code for this bcm should be 112000 but it is no where to be found.

Building I am working in network number for these devices are 112 but i cannot find global code with these numbers at all. I went through all the ddc code and found nothing. Is there a way to find...

Thanks guys it was the IP address conflict that was causing the issue. Working good now.

My laptop I use with this device has been working fine until lately. I need to go into the settings to change my network number but i cannot get the router config page to open. I have windows 7 does...

Yes thank you for the advice. I was looking at alerton standard bitmaps and prog and was trying to find some smaller code to go over and work with.

What is the way to learn how to write code in visio. Are there any good books or online training Thanks

Yes I agree just wondering if anyone has had issues with this model controller flame rod and grounding are good.

Our Church has two Weil Mclain boilers model number is cp3513605 I cannot get micro amp reading any higher than about .80 amps. We ran new ground wire back to control panel and still nothing. I...

This system is about 5 years old, I don't have the model or serial number at this time. It is a cooling only with two power heads, in the past I had freon leaks every season but not this year. This...

There is glycol in the system now but I will have to test to see where I am at now.

Thanks for the advise.

I work on rtu most of the time can you give me some advise.

I have not worked on a comercial boiler in quite a while. Today at my church I was trying to replace the low water cut off. There was no room to work on this it was very hard to get union nuts loose....

Today I installed my first True steam humidifier. The controls were true IAQ setup every time I seem to install these the outdoor sensor it is always reading way off on temp. The sensor was all the...

The furnace is in a closet space that is insulated up in the attic area. So we don't have to worry about freezing in that area.

This installtion is up in a attic space with no floor drain to work with. Just a condo pump to discharge the water. That is what concerns me is the hot water when it discharges into pump.

I just want to make sure the condensate pump can handle the temp of the water and discharge amount.

Does anybody know if the 6 gal true steam Honeywell humidifier can discharge water into a condo pump? It sounds like they discharge quite a bit of water at one time. Thanks Grove

Does anybody no where a person can purchase some test spray in a can.?Aprilaire does not carry this product no longer.

Have you ran into this befor?

I did speak with a HW rep today either the t-stat is acting up or setting on stat is set on option 2 or 0 on the parameter number 370. I will check when I go back to the customers house.

I was finishing up at the house today and all of a sudden the t-stat showed error 54. All of a sudden the humidity reading went away and caused this code. Outdoor sensor is installed for this...