Search:

Type: Posts; User: calubeda

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    14
    Views
    503

    don't recommend to keep pressing reset. call a...

    don't recommend to keep pressing reset. call a pro.
  2. Replies
    28
    Views
    1,907

    and as far as mistakes go people who don't make...

    and as far as mistakes go people who don't make mistakes don't DO anything. I keep saying that.
  3. Replies
    10
    Views
    639

    just had my first no heat call.

    isn't a little too early?
  4. been to one install job after the equipment in an...

    been to one install job after the equipment in an office was robbed . Thieves took the coils but made it look like the units were still there. the installer and I had to replace 4 condensing units.
  5. Replies
    9
    Views
    656

    http://www.emersonclimate.com/en-us/Products/Therm...

    http://www.emersonclimate.com/en-us/Products/Thermostats/Sensi/Pages/sensi-wifi-thermostat.aspx
  6. Replies
    26
    Views
    1,459

    I was looking for a call with about the same...

    I was looking for a call with about the same problem I just saw today. This one it is. The old company I used to work for installed a 5 ton Trane seven years ago and didn't increase the return to...
  7. Replies
    31
    Views
    1,390

    going through a ceiling comes to mind

    going through a ceiling comes to mind
  8. Replies
    31
    Views
    1,390

    I removed a dead possum two months ago. I asked...

    I removed a dead possum two months ago. I asked the dispatcher what to charge. My flat-rate book doesn't have a dead critter removal fee.
  9. Thread: Flush

    by calubeda
    Replies
    37
    Views
    1,816

    at work, my boss is not flushing anymore. New...

    at work, my boss is not flushing anymore. New line set.
  10. + 1

    + 1
  11. Replies
    26
    Views
    1,232

    + 1 on Bacharach. My boss gave us one. I

    + 1 on Bacharach. My boss gave us one. I
  12. Replies
    43
    Views
    4,472

    That was good advise.

    That was good advise.
  13. Replies
    615
    Views
    108,729

    a few years back, I got one of those. Elderly...

    a few years back, I got one of those. Elderly customer couldn't open the t-stat lid to set the heat. No charge, a Prez account. He gave me a $5.00 tip.
  14. Replies
    615
    Views
    108,729

    I had a noise call about a month ago. Our...

    I had a noise call about a month ago. Our company had just replace the filters. no real noise just regular noise from the system. I spent 20 minutes trying to convince her that there was nothing...
  15. Replies
    39
    Views
    2,464

    Wait until you have a call on a Saturday...

    Wait until you have a call on a Saturday afternoon at 5:00 o'clock and you have to give a quote on a new compressor because the home owner kept flipping the breaker for hour and a half instead of...
  16. Replies
    45
    Views
    2,694

    I also cut the shaft and then use a punch. ...

    I also cut the shaft and then use a punch. haven't had any problems
  17. "CU are not always situated 5" above a grassy,...

    "CU are not always situated 5" above a grassy, manicured lawn." had two of those lately and they were also full of dirt. Took about 3 hours to clean them. Customer observed the whole AC check and...
  18. Replies
    109
    Views
    7,671

    Used to get dirty

    my boss is using that low sulfur bio and very few get as dirty as they used to. I did on Sunday on one that got the chimney base stuffed with soot.
  19. Replies
    5
    Views
    553

    thanks for the replies. I'll bring some of those...

    thanks for the replies. I'll bring some of those ideas to my boss.
  20. Replies
    5
    Views
    553

    condensing unit in enclosure

    I was in an AC check on Friday and found the condensing unit enclosed with a private fence. Just for curiosity I checked the temperature in the area and found about 10 degree difference outside the...
  21. Replies
    17
    Views
    1,441

    Blower rotation

    A few years back, I went to a no cooling call. At the time, the blower motor had been left turning the wrong way. Fast forward to today, I got the same call for the same customer and someone had...
  22. Replies
    16
    Views
    1,866

    Do you know any of them? One of the installers I...

    Do you know any of them? One of the installers I help learned to lower the pressure on the boiler trying full pressure. I usually close the isolation valves and get some water out.
  23. I had one call where the home owner turn off the...

    I had one call where the home owner turn off the water heater breaker. I checked for voltage after taking the lower element cover and my reading was about 240 volts. I had to go look for the real...
  24. Replies
    41
    Views
    4,228

    http://natureaircorp.com/downloads/rheem/13pjl/rhe...

    http://natureaircorp.com/downloads/rheem/13pjl/rheem_13pjl_specifications.pdf
  25. Replies
    25
    Views
    1,792

    In the words of an installer I work with from...

    In the words of an installer I work with from time to time, "it is not too late, get out!"
    It was a couple of summers and now I'm back to service.
Results 1 to 25 of 47
Page 1 of 2 1 2
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event