Search:

Type: Posts; User: gmcmickle

Search: Search took 0.00 seconds.

  1. After some tinkering around with it, it seemed I...

    After some tinkering around with it, it seemed I was polling the boxes too quickly on the Lon link. Once I slowed the poll rate down, they started behaving much better. Thanks to those who helped.
  2. I will try checking again in Rover. I don't...

    I will try checking again in Rover. I don't recall seeing alarms before, but maybe I wasn't looking in the right place? The top level screen when you double click on a VAV in the network shows the...
  3. These boxes are enabled by a schedule, so they do...

    These boxes are enabled by a schedule, so they do go unoccupied every day.

    As far as the override points, they are typically not being used, but the customer has the ability to control certain...
  4. Trane VV550 (Lon VAV) to Tridium Jace 6 integration

    I have a customer site that consists of all Trane Lon controllers (VAV, AHU, Chiller) that I integrated to a couple of Jace 6 controllers. The Lon link for the controllers was removed from a Trane...
  5. Replies
    28
    Views
    2,989

    My CCP system is the older CCPII which uses a...

    My CCP system is the older CCPII which uses a remote discharge air temp sensor, duct static sensor, and bypass damper actuator. I believe it's the newer CCPIII that has the communicating UCM (Trane...
  6. Replies
    28
    Views
    2,989

    dllhvac, can you tell me what the range and...

    dllhvac, can you tell me what the range and output is of the Trane Velocity/Static pressure sensor is? I realize the sensor can output either velocity or static pressure based on a 90 degree...
  7. Replies
    28
    Views
    2,989

    dll, does the comm4 driver allow the jace to see...

    dll, does the comm4 driver allow the jace to see all the points the customer would be accustomed to seeing through their old Tracer Summit front end? For example, the fan status of the RTU on a CCP?
  8. Replies
    28
    Views
    2,989

    Thanks again for your help. I'm thinking the...

    Thanks again for your help. I'm thinking the Jace 2 with comm4 driver may be the best solution. So if I needed support for the driver after purchase, I would contact infocon?
  9. Replies
    28
    Views
    2,989

    Thanks for your reply dllhvac. I am looking at...

    Thanks for your reply dllhvac. I am looking at how to tackle a job that has 4 CCPII VVT systems and one Reliatel/TCI card RTU all tied into one BCU. Two of the CCPs have 6 VAVs each, the other two...
  10. Replies
    28
    Views
    2,989

    I am preparing to do a similar project. Can you...

    I am preparing to do a similar project. Can you give an update on how yours ended up working?
  11. Replies
    157
    Views
    27,300

    setupMS3.exe

    I am wondering if someone could send the setupMS3.exe software too. I'm working on a project where this might help. Thanks!
Results 1 to 11 of 11
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event