Search:

That is the oil that is in the picture. You can see it bubble out the leak without adding any bubbles.

I am having a problem with some Carlyle scroll compressors. Model # SRH752AC01. One of the welds on the casing that holds the stator in place leaks refrigerant and oil out of the center of the...

http://www.frigidaire.net/Frigprod2.asp#top%20of%20page
try this link for some info.

ain't nothin' better than a pack of pez.

My brother has one ... I'm thinking of getting one,they are definetly the way to go.

Some neighborhood kid has put an airhorn off a train on his truck,you talk about loud!We don't live within ten miles of the tracks and the lady next door came out the other day and asked me if a...

We have used a helicopter a couple of times, we set all the equipt. on a shopping mall with one,did in a day that would have taken a week or better with a crane and crew.We were only aloud 4 guys on...

We have used Heatcraft before, really nice.The local rep came to the job and did all the measuring and pipe sizing himself.They shipped us the coil and you would have thought it was the...

I furnish basic hand tools,if it is a tool for hvac,then it is furnished.I just recently handed down my van to my helper and got a new one.I got to go buy all the latest and greatest equipment for...

I hate to wish it upon anybody else but it can sure keep going west.

The projected position on tues. is directly over our house.!!!!HELP!!!!! not again

I'm in lakeland ,Florida. I made out just fine ...a few broken tree branches and boat load of water on the ground.

When I use to drink I liked Amberbock...ahhhhh the days, Black and tan was also a good one

Our store doesn't carry the craftsman snips anymore, the warranty became a problem. they sell them under the sears name without the replacement warranty. I do have the offset aviation snips from...

I use two spanner wrenches with the 3/16" pin. you remove the set screw and put the wrench on there and they work great.

Hey Dash we made it thru ok a few tree branches lost...
Yes,I know a couple of the guys at Payne, they are installers.

I live in Polk county (Lakeland). The storm has turned to hit us head on. I've concluded that it is after the people that live along the coast,they all evacuated to our area and now it's coming...

I gave my boss a bottle of Daves insanity sauce "Limited Edition"for Christmas. It is signed and numbered by Dave and comes in a wooden coffin.At the Christmas party he set it out on the table and...

If I know ahead of time we will have to pull the charge on a big unit,I take a cooler of ice with me to set the jug in.works like a champ.

Lakeland, Florida 10

our copper is around $1.00 a pound.
coils are around .50 cents a pound.

we did a small job that had 8 units on it. Our guy that ran the drains did it just the same way. I asked him what was wrong with the picture? He had know idea, so I explained the whole thing to...

It is against code in our neck of the woods.Disconnect must have three feet of clearance in front of it,measured from the cover not the wall it is mounted on.

commonly referred to as duct on a roll.

We installed 5 identical AAon units on a job,It was a gaurantee that the same thing would break on all units at the same time.Had the same leak in the same fitting on all units,All phase monitors bad...