Search:

Type: Posts; User: TheTerminator

Search: Search took 0.00 seconds.

  1. Replies
    4
    Views
    936

    I had ran into this same issue. I had found that...

    I had ran into this same issue. I had found that the actual point in the Andover programming was programmed as though it was a sensor input on the device. This must be an Andover standard way of...
  2. I don't think there has been anything developed...

    I don't think there has been anything developed for the XL10 controllers in the way of offline simulation. The spyder controllers have a simulation mode.
  3. Replies
    7
    Views
    743

    Oops. Good point. Thanks for the correction!

    Oops. Good point. Thanks for the correction!
  4. Replies
    7
    Views
    743

    Go to your LonLinkManager and verify that the nci...

    Go to your LonLinkManager and verify that the nci is bound.
  5. Replies
    6
    Views
    1,198

    The only way I know of communicating to the field...

    The only way I know of communicating to the field controllers is with the Infinity Driver offered. It does not integrate directly to the field bus. It relies on a serial connection to the andover...
  6. Replies
    14
    Views
    3,424

    Really Cool! I couldn't resist investing in one...

    Really Cool! I couldn't resist investing in one of their developer kits.
  7. There should be a "nciTmpOffset"

    There should be a "nciTmpOffset"
  8. Replies
    5
    Views
    1,170

    326821326831 This should help you correct your...

    326821326831

    This should help you correct your libcpp-so-4 issue

    Also read this blog about upgrading / downgrading.
    http://www.niagara-central.com/ord?portal:/blog/BlogEntry/154
  9. If this device is the unit controller and not...

    If this device is the unit controller and not just a network temperature you will want to find the calibration snvt like Keith mentioned. Otherwise by adjusting the proxy extention, you will only be...
  10. Replies
    7
    Views
    1,155

    Assuming your station is running on your computer...

    Assuming your station is running on your computer and the LonNetwork is not in a fault state, then I would suggest reloading the lon driver on your computer. You can find the most up to date driver...
Results 1 to 10 of 10
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event