Search:

Type: Posts; User: tonyv

Search: Search took 0.00 seconds.

  1. Replies
    16
    Views
    4,653

    TGG, I have a 2-stage furnace with a variable...

    TGG,

    I have a 2-stage furnace with a variable speed blower. There are 12 different fan settings. It is set to one of the slowest settings. I have tried to increase the speed with no luck in...
  2. Replies
    16
    Views
    4,653

    kwilcox, Thanks. I have room for either the...

    kwilcox,

    Thanks. I have room for either the Vortex or the Fantech. They seem to be around the same price, although the Vortex seems a lot more powerful (450 CFM vs. approximately 250 CFM). Is...
  3. Replies
    24
    Views
    2,093

    I have an Aprilaire 600 by-pass humidifier for a...

    I have an Aprilaire 600 by-pass humidifier for a 4500 square foot home (one forced air heating zone as the home was built in 1935). The home is old but not very drafty, and this humidifer can...
  4. Replies
    16
    Views
    4,653

    HeatKing, All rooms in our home are well...

    HeatKing,

    All rooms in our home are well balanced regarding temperature except for this room. It was always too cold in the winter and too warm in the summer. With the installation of a simple...
  5. Replies
    16
    Views
    4,653

    In-Line Duct Fans - HELP

    Hi everyone,

    I currently have an in-line duct fan installed on a 6" duct that is furthest from my furnace. It turns on/off with the furnance and has helped tremendously in keeping this room...
  6. Replies
    29
    Views
    3,344

    As a homeowner, I feel compelled to reply. When...

    As a homeowner, I feel compelled to reply. When I purchased my home ten years ago, it needed a new furnace. I had a Carrier furnace installed (92% efficiency) based on the name -- figured it had to...
  7. Replies
    11
    Views
    4,153

    Mayguy, There is a common wire that was used...

    Mayguy,

    There is a common wire that was used with our previous Honeywell thermostat, but it doesn't work with the Honeywell VisionPRO.

    We have a 2 stage furnace that is located in the basement,...
  8. Replies
    11
    Views
    4,153

    Mayguy, I have a VisionPRO TH8321 thermostat...

    Mayguy,

    I have a VisionPRO TH8321 thermostat (with dehumidification control, but not the new IAQ). I installed it myself and didn't realize that I could run a jumper to indicate when the system is...
  9. Replies
    15
    Views
    4,233

    Before spending the money to have a Manual J...

    Before spending the money to have a Manual J calculation performed, be sure that your thermostat is properly controlling your 2-stage equipment. Check the installer codes for your thermostat (if you...
  10. Replies
    4
    Views
    868

    As a homeowner, I will NEVER live in another...

    As a homeowner, I will NEVER live in another house without 2 stage forced air heating. I live in NJ, where we heat from late September through early May. I recently opted for a 2 stage, variable...
  11. Replies
    4
    Views
    1,166

    Thanks mayguy. I would actually like the light...

    Thanks mayguy. I would actually like the light to stay on all the time, which is why I was hoping I could use the common connection. Because my common wire is connected to the heating transformer,...
  12. Replies
    4
    Views
    1,166

    Hi everyone, Based on recommendations I have...

    Hi everyone,

    Based on recommendations I have read here, I installed a VisionPRO TH8321 thermostat (with dehumidification control) this past weekend. Everything is working well.

    However, I did...
Results 1 to 12 of 12
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event