Search:

Type: Posts; User: bluke1

Page 1 of 3 1 2 3

Search: Search took 0.01 seconds.

  1. Yearly maintenance is important. Parts are...

    Yearly maintenance is important. Parts are inspected and cleaned, and proper performance and early signs of problems can be identified. There is alot more to servicing equipment then a filter change.
  2. Silly question, but why won't they run a new...

    Silly question, but why won't they run a new wire? Is it between floors, because I wouldn't do that, either. The wireless thermostat may be a good option for you. You would be able to fully utilize...
  3. Replies
    5
    Views
    976

    Great reply, rundawg. Just to add a little, the...

    Great reply, rundawg. Just to add a little, the DSI also has purge times before, and between ignition attempts. This is to purge any gas from a failed ignition cycle. It also allows the...
  4. Replies
    21
    Views
    2,087

    Thanks, guys. I'm in Oklahoma, where natural gas...

    Thanks, guys. I'm in Oklahoma, where natural gas is king. I've never personally laid eyes on an oil-fired anything. I will likely buy both a pump and portable heater, both are good to have and the...
  5. Replies
    21
    Views
    2,087

    Thanks for the advice. I have researched the...

    Thanks for the advice. I have researched the question before I asked here. The local trane office told me that their method was to warm the chiller. I have searched gear pumps, but most seemed too...
  6. Replies
    21
    Views
    2,087

    how to warm up a centrifugal

    I need to do an oil change on a CVHE. There is no hot water available near the chillers, so I need to find a portable water heater solution to warm the barrel. Preferably without taking 6 hours....
  7. Replies
    10
    Views
    1,032

    What is the amp draw? The overload will open if...

    What is the amp draw? The overload will open if the current is to high. It could be any of the electrical components, or wiring, that are causing your problem.

    Edit: I re-read the rules, and might...
  8. Replies
    78
    Views
    8,031

    Just make sure you continue your education while...

    Just make sure you continue your education while you find your next job. Employers like that.
  9. Replies
    15
    Views
    2,315

    Use the low temp limit in the fancy new digital...

    Use the low temp limit in the fancy new digital thermostat to prevent them from setting it below 68*F.

    Refrigerant pressures are only a small glimpse into what the system is doing. Subcool,...
  10. Replies
    1
    Views
    958

    Updated. Airflow issue was resolved by...

    Updated. Airflow issue was resolved by configuring for another model and a psc blower, cycling power, resetting correct configuration, and cycling power. Instructions from tech support. Compressor...
  11. Replies
    15
    Views
    2,981

    I didn't dig up the old thread, but I read it. He...

    I didn't dig up the old thread, but I read it. He mentioned coated air coils. Do it. I don't know about you, but regardless of manufacturer, I have been replacing a number of coils. Have read and...
  12. Replies
    1
    Views
    958

    climatemaster TED compressor issue

    Installed a climatemaster TED038 friday. Installed the communicating thermostat as well. System ran fine, maintained around 10 degrees suerheat, subcool was 15- 18 as the txv modulated.

    I have 2...
  13. Sticky: I Learned a lot being stuck by myself as a...

    I Learned a lot being stuck by myself as a maintenance guy with a little votech experience. I read a lot of books ( internet was not around then). After I gained experience I went to work for a...
  14. Replies
    3
    Views
    468

    quoted for truth! read and compare in house...

    quoted for truth! read and compare in house ratings and customer reviews. it will give you a good idea of what options you have in your tire size. some sizes have more options then others. hope you...
  15. Replies
    12
    Views
    1,369

    that's a nice find! i have never even seen the...

    that's a nice find! i have never even seen the spout-type can before. pretty cool.
  16. Replies
    12
    Views
    1,694

    how did the health department miss that?

    how did the health department miss that?
  17. Thread: rtaa chiller

    by bluke1
    Replies
    20
    Views
    1,823

    thanks, i think i will try that. :payattention:

    thanks, i think i will try that. :payattention:
  18. Thread: rtaa chiller

    by bluke1
    Replies
    20
    Views
    1,823

    update: i took the advise of a few of you and...

    update: i took the advise of a few of you and swapped compressor control boards. compressor ran normally with good board swapped in place. when i removed the cardboard protector off the back of the...
  19. your right, and you get a bonus point for...

    your right, and you get a bonus point for correctly spelling mui! i guess i haven't worked on any of the newer envisions, although i am very familiar with the premier board. thanks for clearing that...
  20. Thread: rtaa chiller

    by bluke1
    Replies
    20
    Views
    1,823

    loose connection caused the fire. ALL connections...

    loose connection caused the fire. ALL connections were checked/tightened. i watched the electrician check the main feed. phase abc are correct. i suspect that when the insulation melted of the high...
  21. maybe its commercial only. its a data tool called...

    maybe its commercial only. its a data tool called a "muay" that plugs into the board. you get real time sensor readings, fault codes, etc. i have worked on a couple dozen of the commercial ones, but...
  22. Thread: rtaa chiller

    by bluke1
    Replies
    20
    Views
    1,823

    thanks, i had thought about swapping the known...

    thanks, i had thought about swapping the known good one for the questionable one, but didn't know if there was an easier solution. the addresses have not been changed ever because both are origional...
  23. Replies
    111
    Views
    50,053

    you might want to look at the rest of the joints,...

    you might want to look at the rest of the joints, if they missed one, they could have missed more.... do it for your piece of mind. look around at the rest of it for obvious problems, hopefully it...
  24. i haven't liked the envision like the previous...

    i haven't liked the envision like the previous posts have. i do, however, agree with everything they posted about using a 2 stage unit. have you looked into the climatemaster? electronics are much...
  25. let me be the first to ride the fence.... i...

    let me be the first to ride the fence.... i believe that some of your statements are true. not every truck for every company is stocked with a proper combustion analyzer. and many furnace problems...
Results 1 to 25 of 57
Page 1 of 3 1 2 3
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event