Search:

It really looks like Easy IO systems are the way to go and all. Do they have distributers or will they sale the parts and software directly. Also how are the graphics?

Our maintenance staff gets 2 hours of comp time for each day of being on call plus time and a half for being called out.

I seem to remember that i had to upload my NCMs after I made any changes so GPL could find the points.

You could search the GPL or JC basic files to see if a point is shared to a point.

The NCM will only reload if there are no errors in the database. Been there, done that , got the t-shirt!!!

Sometimes sites have controllers that are not supported by an NAE. For example if you have DCM's then you are tied to an NCM,

What about using NCMs with PMI?

There's also an option to generate a bas file I think. Then you can look at the code in jc basic.

What do you use to commission these new controllers and how do they map into PMI???

Would definately stay away from this scenario. The XBS and EBI don't tend to play well together. I can't wait to rip all the controllers out and start from scratch!!!!

I remember they put those controllers in boilers. Anyways get a http://www.kele.com/transducers/res-1e.aspx and you can use a 0 - 10 volt signal to control the 135 ohm controller..

If its to communicate with an older controller you probably need to be on a certain comm port, usually com 1 or 2.

Also I agree with BillControls about the layering of an NAE on top of a NCM. Then you have to know both systems and troubleshooting is more difficult.

Smoke control processes can be an issue depending on different factors.

I would totally go that route, just make sure you can send the NAE back if it doesn't work. You could configure the new controller on the N-2 buss and then put back the old NAE until your finished....

What year is the generator. Back in the day we had issues with shielding generators causing interference with electronics. Sometimes you could provide a better ground for the gen set and it would get...

I've seen distances of N-2 busses that would stagger the mind and still work. Although I've had to make sure the shielding was correct and the distance between controllers not be too great. I would...

I also think most people moved on from pneumatics but quite a few people still respond to pneumatic questions. I thought maybe Honeywell prohibited their people from Hvac-Talk.

I was under the impression that there were quite a few Honeywell systems installed all over the country in the 80's.

I just noticed we don't have the number of reponses on Honeywell that we do from other manufacturer lines. Then of course the conspiracy theory in me took over and I asked the question.

I was wondering about the talent we have on HVAC Talk. It seems to me that pneumatics is well represented along with Johnson, Seimens, Trane etc... I was wondering about Honeywell, the "Big Red". It...

http://necc-controls.com/vav/kreuter-pneumatic-vav.html

Someone probably took out the reverse reset volume regulator. This part reverses the signal and lets you set the minimum and maximum air flows

366351

When we go into EBI alarm management of a R-7044 analog input, the alarm point value is shown as red dashes.