Search:

Type: Posts; User: Osgood Conklin

Page 1 of 3 1 2 3

Search: Search took 0.00 seconds.

  1. Replies
    6
    Views
    1,978

    I have found that many small chunks of charcoal...

    I have found that many small chunks of charcoal tend to smother air inside the chimney. My bright idea works good: Take a toilet paper cardboard roll and hold it inside whilst you pile the charcoal...
  2. UPDATE Trane tech just left. He opened the...

    UPDATE

    Trane tech just left. He opened the cover, pulled out the pre-filter and put it back. Closed the cover and said "one latch was not right. It was only half closed". He pulled the power...
  3. Pre-Filter red light blinking. Just cleaned ??

    Our 2011 Clean Effects on a new 16i/Hyperion was serviced 11/21 and Trane dealer cleaned all the filters with a hose and water, which he thought was fine....but I have been reading this might not be...
  4. Replies
    4
    Views
    1,023

    Thanks for the reply. I have a 16i not an 18i. ...

    Thanks for the reply. I have a 16i not an 18i.

    I have been noticing that the temp sensor inside the outdoor unit tells the X950 that ambient air is 5 to 10 degrees warmer than my readings. The...
  5. second O: Did you mean the lockout setpoints...

    second O:

    Did you mean the lockout setpoints can be between 0 to 50 degrees?
  6. UPDATE. 11:15 OR time. 48 degrees outside. ...

    UPDATE. 11:15 OR time. 48 degrees outside. Compressor on. Back to normal. Outdoor sensor says 50 degrees, so there is a 2 degree difference, not the 3-5 degrees I postulated.

    I let you know...
  7. Hi all and thanks for your replies. I talked to...

    Hi all and thanks for your replies. I talked to one of the installers (who now works for another company) and he said he set the lockout for 35 degrees. It was about that cold this a.m.

    It is...
  8. I changed both 40A fuses..... two times. ...

    I changed both 40A fuses..... two times. Compressor will not start when I ask T-stat to up the heat. Just strips.
  9. Well, as luck would have it, just now I have...

    Well, as luck would have it, just now I have stage 1 or 2 heat strips ON without the compressor being on. Air flow is about 40-50% out of the registers....altho the 950 display says air flow is...
  10. Replies
    4
    Views
    1,023

    Trane XL950: Defrost cycle show ?

    New XL18i and Hyperion A/H with above stat.

    I don't see in the XL950 User's Guide (or on the stat panel) if a defrost cycle has been activated.

    My guess is it might not show. Anyone have the...
  11. I see there is a relay panel attached to the side...

    I see there is a relay panel attached to the side of the A/H. It is BAY24VRPAC52DA. I have the installation guide.

    It appears that if I take the cover off, there are lights inside that will tell...
  12. Replies
    23
    Views
    1,418

    Well, yeah I knew that. But why pay the power...

    Well, yeah I knew that. But why pay the power company when you have cheap power already stored up in your battery bank.
  13. adam. Dealer went out of business. Yes it is a...

    adam. Dealer went out of business. Yes it is a H/P. PS: are you related to Bill W. from TX?

    cat. The XL950 is the newfangeled one with a 7"x4" digital screen.
  14. Replies
    23
    Views
    1,418

    For cooling after the sun goes down.......would...

    For cooling after the sun goes down.......would you not need a large bank of 6V HD batteries to release their electricity via an inverter to change voltage back into 120V AC?
  15. Trane: How to tell if heat strips are on ?

    Our installing dealer went kaput. I can ask other local Trane dealers but I thought I would start here.

    New XL16i with TAM7AOC42H Hyperion and BAYEVAC10BK1A electric heaters. XL950 T-stat.

    I...
  16. Re hitting the RESET button: If I hold it down...

    Re hitting the RESET button: If I hold it down for 1-2 seconds only the red flashing light will go off. Right? This is what I want as I am ONLY cleaning the pre-filter.

    If I continue to hold...
  17. second opinion: The XL950 is difficult for me...

    second opinion:

    The XL950 is difficult for me to navigate. Even tho I have the user's guide. Thought I could bypass fooling with it......and by turning off the Hyperion circuit breaker......it...
  18. Clean Effects pre filter: cleaning procedure OK?

    Rather than shut off the XL950 t-stat, I thought I could hit the C/E power button to OFF, pull the small power cable and shut off the circuit breaker on the Hyperion and pull the C/E door off. Sound...
  19. Replies
    3
    Views
    618

    Thanks. Our dealer closed up their doors...

    Thanks. Our dealer closed up their doors recently. All techs are gone.

    Do you think the installer looks at the house interior and surrounding area and sets the time based on those parameters? ...
  20. Replies
    3
    Views
    618

    Question about Trane Clean Effects

    I was told that the mechanism for the Clean Effects telling me it is time to clean the filter/cell is..........elapsed time. You watch the green blinking lights go up the scale until a flashing red...
  21. Replies
    1
    Views
    630

    Air sealing results. Seem OK ?

    2200 sf single level house. 2 occupants, 3 bedrooms.

    Pre CFM50 4028
    Pre VP 175

    Post CFM50 1649
    Post VP 72

    The air sealing...
  22. Trane area rep in southern Oregon ???

    There is some discombobulation in a local Trane office. We just had some equipment installed and now are a bit worried about service due to recently departed personnel.

    In order for me to stay...
  23. Replies
    13
    Views
    1,554

    TESP is Totally Enclosed Static Pressure ???? ...

    TESP is Totally Enclosed Static Pressure ???? Could not find in HVAC glossary and is a guess. How did I do?
  24. Replies
    22
    Views
    1,250

    try www.johnmills.net for various mfrs and...

    try www.johnmills.net for various mfrs and sub-brands
  25. Replies
    16
    Views
    1,883

    The reason I asked my question is.......I am the...

    The reason I asked my question is.......I am the dimwit who roofed in his pool equipment area which also contained our old 1993 York condenser. The exhaust air was restricted and it was a lot colder...
Results 1 to 25 of 63
Page 1 of 3 1 2 3
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event