Search:

Type: Posts; User: hvactech08

Search: Search took 0.00 seconds.

  1. Replies
    3
    Views
    541

    thanks for the response, the millinium board is...

    thanks for the response, the millinium board is setup for 2 stage and the modulating furnace control is setup for 3 modules, it does indeed have three modules and the mfc board is not faulting any...
  2. Replies
    12
    Views
    1,182

    your cracked heat exchanger is definitley the...

    your cracked heat exchanger is definitley the culprit, it causes the slower velocity of the combustion fumes and the flames have a harder time pulling thru properly, hence on a windy day they dont...
  3. Replies
    3
    Views
    541

    johnson very abstract problem

    I have this york/johnson rtu M#v33ad54a5idaaloo1, when the heat is enabled from main board to the modulating furnace control (staging relay control board), the third-five cell heat module creates a...
  4. Replies
    2
    Views
    517

    two cleaver brooks boilers lead lag

    I've got large cleaver brooks boilers piped in for lead lag and with a mixing valve for the secondary loop, both circ pumps run below 55deg, although when the right boiler runs on lead, the left...
  5. Replies
    2
    Views
    746

    ill check that out thanks

    ill check that out thanks
  6. Replies
    2
    Views
    746

    tracer summitt version 17

    I recently had an issue where my trane ahu discharge air sensor reading at the front end was out of range (ten degrees below actual) despite an acceptable ohm value at a given temp (i checked it...
Results 1 to 6 of 6
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event