Search:

Type: Posts; User: bf - pa

Search: Search took 0.00 seconds.

  1. Replies
    27
    Views
    10,444

    thank you, all, for continuing this thread. Now...

    thank you, all, for continuing this thread. Now I'm wondering if I have undersized circulator pumps... Though I've been pretty happy with not setting the thermostat way back. And response time when...
  2. Replies
    2
    Views
    1,731

    Thanks as always, Johnsp! I'm definitely going...

    Thanks as always, Johnsp! I'm definitely going to have them check about fire tube size. That makes most sense to me. They did try to lessen the draft thinking that system was tuned up in warmer...
  3. Replies
    27
    Views
    10,444

    I have a Riello burner as well. I posted this...

    I have a Riello burner as well. I posted this problem as a new thread and Johnsp mentions that he thinks they might have changed the specs on size of the fire tube using the Riello with the Buderus...
  4. Replies
    2
    Views
    1,731

    burner problem with Buderus boiler

    Anyone have similar experiences with a Buderus oil boiler as the following?

    The installer/repair folks, after 4 visits to correct the problem, told me that the flame was pulling off the burner...
  5. Replies
    27
    Views
    10,444

    Hello Paul, When I spoke with Ernie at Buderus...

    Hello Paul,
    When I spoke with Ernie at Buderus tech support in Dec 06 he thought the heating curve the installers used was too low at bottom end. Convection in hot water systems doesn't occur till...
  6. Replies
    27
    Views
    10,444

    Pauldv, When I get a chance over the next few...

    Pauldv,
    When I get a chance over the next few days I'll take a look at the settings I settled on. I ended up speaking with a Buderus person who gave me some good info and I'm happy with the...
  7. Replies
    27
    Views
    10,444

    I've been away for a week. I'm looking at the...

    I've been away for a week. I'm looking at the Logamatic manual and it describes the boiler function for the Setback parameter (which is how I have it set, and it means there are no Buderus room...
  8. Replies
    27
    Views
    10,444

    I couldn't figure that one out (about no room...

    I couldn't figure that one out (about no room sensor), but the manual says if no room sensor, set the logamatic on SETBACK, and if you have a room sensor, use OASETBACK. If I recall, the Setback...
  9. Replies
    27
    Views
    10,444

    We have a fairly new Buderus oil boiler w/...

    We have a fairly new Buderus oil boiler w/ indirect. Have 3 zones (one heating circuit) in modest sized home in eastern Pennsylvania (near Easton). The logamatic controls the boiler and we have the...
Results 1 to 9 of 9
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event