Search:

Type: Posts; User: 2Cold

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    15
    Views
    4,781

    then i'll be out of a job.. *sigh*:(

    then i'll be out of a job.. *sigh*:(
  2. Thread: Carrier

    by 2Cold
    Replies
    17
    Views
    1,530

    good men AND women.. ;) (sorry, messed up...

    good men AND women.. ;)

    (sorry, messed up quote replying in last post)
  3. Replies
    8
    Views
    613

    haha

    haha
  4. Thread: Carrier

    by 2Cold
    Replies
    17
    Views
    1,530

    .

    .
  5. Replies
    17
    Views
    1,313

    welcome and congrats

    welcome and congrats
  6. I would definately insist on getting the infinity...

    I would definately insist on getting the infinity control. In my opinion, it is a must have in this case. Thermostats and units are not always mix and match. Hey, if you're splurging on a great...
  7. Replies
    23
    Views
    22,690

    Dont Use Four Seasons In Bridgeview!!!!

    Keep your vendetta off our board!
  8. Other than 1.5 tons. I know that some units...

    Other than 1.5 tons. I know that some units allow 1/4 & 1/2" lines.
  9. Freon line sizing on 13 seer and up...problems with 1/2/" and 1/4" lines??

    We are running across contractors that are installing new systems and telling customers that its OK to us 1/2" and 1/4" lines. We know that this is wrong. Does anyone have anything in writing from...
  10. Replies
    18
    Views
    1,703

    Easy...None. Go with and American Standard...

    Easy...None. Go with and American Standard (Trane). Period.
  11. Replies
    114
    Views
    11,410

    Poll: NOTHING ....exactly the same internally

    NOTHING ....exactly the same internally
  12. Replies
    2
    Views
    496

    Yes you are correct and I did check the low and...

    Yes you are correct and I did check the low and line polarity against the schematic. The ground that is providid in the factory handy box in the furnace was not connected and never has been. This...
  13. Replies
    2
    Views
    496

    Went to work on a Trane 5-6 yr old TUA single...

    Went to work on a Trane 5-6 yr old TUA single stage with silicon nitride. Found a ignitor totally blown apart. I put in a new one and now I get a number 3 fault, which says a bad pressure switch. ...
  14. Replies
    47
    Views
    3,563

    Hey have them check for PROPER polarity on the...

    Hey have them check for PROPER polarity on the line in side as well as on the 24 volt secondary. Make sure they go exactly from the electrical diagram on the 24 volt side.
  15. Replies
    47
    Views
    3,563

    Your flash code..

    Just so you know...downflo's should have "B" vent inside the cabinet as it runs up next to the board. The board gets hot and fails. I have seen 4 flash codes recently...suppose any other should be...
  16. Lennox G20 with spark ignition

    Just worked on one with the same exact problem. After cleaning the fame sensor. Sometimes it would spark up and fire and sometimes it would spark up, pilot would lite and drop out. Check the pilot...
  17. Replies
    20
    Views
    3,464

    Contact me

    If you are in the north burbs call me and ill help. Actually call either way. 847.774.8157 Cell Doug
  18. Replies
    8
    Views
    5,202

    I have a few

    I have a few of the Supco guages. The big thing is that you got to clean the sensors with rubbing alcohol to get the oil off. Make sure the battery is charged. As long as everthing else is good, I...
Results 1 to 18 of 78
Page 1 of 4 1 2 3 4
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event