Search:

Type: Posts; User: fbk007

Search: Search took 0.01 seconds.

  1. Replies
    6
    Views
    564

    No, I don't. Regards, Faisal.

    No, I don't.

    Regards,
    Faisal.
  2. Replies
    6
    Views
    564

    Due to the ultrasonic technology it's necessary...

    Due to the ultrasonic technology it's necessary that the installation should be dead on. As long as it works reliably and for a long time that's fine me.

    Thank you for your contribution!
    :grin2:
  3. Replies
    6
    Views
    564

    It seems that is a very good choice. But it's...

    It seems that is a very good choice. But it's quite a bit expensive!

    Thank you very much! :)
  4. Replies
    6
    Views
    564

    Ultrasonic water flow meter

    Hi all,
    I am looking for an ultrasonic water flow meter with Modbus RTU interface, accurate, and reliable. And not too expensive. :whistle:

    Does anyone could recommend me one?

    Thx!
  5. Thread: Niagara Summit

    by fbk007
    Replies
    22
    Views
    4,806

    Routine; it's an periodical execution of service,...

    Routine; it's an periodical execution of service, program. i.e. the Niagara Network monitor ping feature that executes periodically x amount of minutes in order to check the comm. status of the...
  6. Thread: Niagara Summit

    by fbk007
    Replies
    22
    Views
    4,806

    I have done large central plants (large point...

    I have done large central plants (large point density) and features that would be very difficult to accomplish with programmable controllers. I have used lonworks programmable controllers as IO. I...
  7. Replies
    6
    Views
    1,826

    Long time ago I worked with ASI controllers when...

    Long time ago I worked with ASI controllers when its GUI was Wonderware. Since then had been a lot of changes on their system architecture, software, etc. But I do recall something about the legacy...
  8. I have VAV Stryker controller installed on my...

    I have VAV Stryker controller installed on my office’s VVT. So far the controller has been working ok.
    HW did a good job on the AX wizard, literature (Configuration, SRB (Know issues)), hardware,...
Results 1 to 8 of 9

Related Forums

Plumbing Talks | Contractor MagazineThe place where Electrical professionals meet.
Comfortech 365