Search:

Type: Posts; User: RobertD

Page 1 of 2 1 2

Search: Search took 0.00 seconds.

  1. Replies
    0
    Views
    373

    Boiler problem fixed

    Thanks for all your help. I had posted a problem with a Vallilant boiler that had an intermitent problem with the burner kicking off and not igniting again until the thermostat was reset. I did call...
  2. Replies
    24
    Views
    1,096

    One last post - when the burner does'nt ignite...

    One last post - when the burner does'nt ignite during the circulation of water, I can turn off the stat and wait awhile, turn it back on and the burner will ignite.
    Thanks for all your help. I will...
  3. Replies
    24
    Views
    1,096

    It does happen in above frezzing temps as well.

    It does happen in above frezzing temps as well.
  4. Replies
    24
    Views
    1,096

    Yes, I do have copper tubing running along...

    Yes, I do have copper tubing running along uninsulated walls. It's a brick home built in 1959.
  5. Replies
    24
    Views
    1,096

    Yes, the stat does control the pump. It will show...

    Yes, the stat does control the pump. It will show that it's calling for heat, and the burner will cut off before reaching the setpoint, and the pump will continue to run with cold water in the pipes...
  6. Replies
    24
    Views
    1,096

    Please help with boiler problem

    I've had an issue with a Valliant Boiler which is approximately 10 years old.
    I did what several of you suggested by calling a tech to check it out. They cleaned the flame sensor and tightened what...
  7. Replies
    1
    Views
    567

    Thermostat or Boiler?

    I have a Gas Boiler that on occassion will not ignite yet I hear the circulation pump. I'll have to turn off the heat at the thermostat and wait for awhile and turn back on. I have a Hunter...
  8. Replies
    11
    Views
    1,295

    Thanks to all - this is a great forum!

    Thanks to all - this is a great forum!
  9. Replies
    11
    Views
    1,295

    Good point!

    Good point!
  10. Replies
    11
    Views
    1,295

    Not that it matters much, but it is gas rather...

    Not that it matters much, but it is gas rather than oil.
  11. Replies
    11
    Views
    1,295

    Is my boiler oversized?

    We live in a 1600 ft. brick ranch built in 1959 with a Valiant Gas Boiler (10 years old) with hot water baseboard. The BTU is 120,000. The difference in temperture from one end of the house to the...
  12. Thread: Builder Grade

    by RobertD
    Replies
    4
    Views
    997

    Builder Grade

    Thanks to all
  13. Thread: Builder Grade

    by RobertD
    Replies
    4
    Views
    997

    Builder Grade

    Is an American Standard 3 ton 13 seer ac system considered a builder grade? What is a Duration compressor? Would the 13 seer be adequate if properly installed?
  14. Replies
    3
    Views
    615

    Thanks

    Thanks
  15. Replies
    3
    Views
    615

    Yellow substance on fins

    Had an American Standard ac system installed in Februray. It has done a great job in 95 degree temps keep the set point and keeping RH at 47? I did notice the other day what appeared to be a yellow...
  16. Replies
    4
    Views
    470

    Yes, the comfort level feels good when the temp...

    Yes, the comfort level feels good when the temp is 88 outside.
  17. Replies
    4
    Views
    470

    New AC System and humidty question

    I recently submitted a question about a 3 ton American Standard system in a 1600 sq. ft. brick home and a possible humidity issue. It appears that the unit is maintaining a relative humidity level of...
  18. Replies
    19
    Views
    1,259

    Thanks to all. This is a great site!

    Thanks to all. This is a great site!
  19. Replies
    19
    Views
    1,259

    Is a variable speed air handler necessary for a...

    Is a variable speed air handler necessary for a humidistat?
  20. Replies
    19
    Views
    1,259

    Yes, I do belive the old did a better job with...

    Yes, I do belive the old did a better job with humidity. I did have a new air handler installed.
  21. Replies
    19
    Views
    1,259

    new ac system and humidity

    There was a 3 ton unit prior to the new. I don't think a Manual J was done.
  22. Replies
    19
    Views
    1,259

    New ac system and humidty

    Just had a new American Standard ac system installed. It's a 3 ton 13 seer unit in a 1600 sq. ft. brick home built in 1960.
    The temperature can be set at 76 degrees - feels fine when the system is...
  23. Thread: Honeywell help

    by RobertD
    Replies
    4
    Views
    541

    Honeywell help

    Yes, I will run both from the same stat
  24. Thread: Honeywell help

    by RobertD
    Replies
    4
    Views
    541

    Honeywell help

    I currently have a ac system for cooling and a gas boiler for heat. What model Honeywell Vision Pro 8000 do I need? I'm looking at a 8320 and a 8011. This is a single stage ac system.
    Thanks
  25. Need recommendations on type of Honeywell Thermostat

    I have had several recommend a Honeywell Vision 8000 stat. I have a gas boiler with water baseboard heat and a American Standard split ac system. There are several Honeywell models. What model would...
Results 1 to 25 of 28
Page 1 of 2 1 2
Comfortech Show Promo Image

Related Forums

Plumbing Talks | Contractor Magazine
Forums | Electrical Construction & Maintenance (EC&M) Magazine
Comfortech365 Virtual Event